http://www.1aauto.com/1A/BrakePadAndRotorKits/Chevy/S10-Pickup/1ABFS00327 1A Auto shows you how to repair, install, fix, change or replace your own worn, squ…
http://www.1aauto.com/1A/BrakePadAndRotorKits/Chevy/S10-Pickup/1ABFS00327 1A Auto shows you how to repair, install, fix, change or replace your own worn, squ…
You must be logged in to post a comment.
){kind=link}
You may also want to check any tabs or metal pieces that may possibly be coming into contact with the brake rotors. Hope this helps you out. 1aauto.com 888-844-3393
Okay so bought new pads new calipers new rotors nd new bearings, I believe Ive done everything possible also put that lubricant on the back side of the pads cleaned the rotor bled the brakes….then the trouble im getting high pitch squealing as im breaking please help
You’re welcome. Thanks for watching. 1aauto.com 888-844-3393
Thank you very much for sharing your knowledge
Normally after installing brakes, you will notice a small amount of friction because everything needs to seat itself. The brakes are what is known as a floating caliper so once everything is in its proper place and the brakes are released, the caliper will slide allowing space for the rotor to spin freely.
This was awesome…. Is it normal after installing the new rotors and pads to have a small amount of friction between the pads and the rotor when spinning by hand while on a jack? The tire will rotate about 5 times but can hear a small amount of friction. Im assuming this is ok and brakes need to be broke in.
Thanks for watching. 1aauto.com 888-844-3393
Awesome man, I know what I’m doing this weekend…
You would need to buy new bearings for the new rotor. there may be a race already installed on your new brake rotor. The inner an outer wheel bearing will more than likely be different. 1aauto.com 888-844-3393
do the bearings come in a pair for each rotor? and does it matter which bearing you use for inner and outer? also what is a bearing race?
If you followed the steps in this video you should be fine. You could always take the tire off and check the pads in the caliper to see if they have stayed seated okay.
My haynes manual said something about bending the tabs on the pads around the caliper or something? But I didn’t read that till a few days after I did the brakes. Should I worry?
These wheel bearings were fairly old so we added new ones in. This video will show you how to replace them. If the bearings have fairly low miles on them and are in good shape you can reuse them.
did you used new wheel bearings? or did you use the same bearings? do i have to change them whenever i replace my rotors? how can i tell if i need to replace my bearings?
Dude you are the best! I saved alot of money by watching your videos! Thanks so much!
Thank you for visiting our auto repair channel on YouTube.
you guys do house calls?, properly trained and very detailed video on how to change your front dick brakes on 2000 chevy s10. much appreciated guys.
Thank you for checking out our auto repair videos. Glad we could help you out. Have a great day!
Thanks a lot! saved me a lot of money, i bought the parts and followed your video and my truck works perfectly fine!
you’re welcome. Thank you for visiting our YouTube auto repair channel.
Awesome video thanks a lot it’s a lot of help.