How To Install Replace 4×4 Dash Switch Chevy S10 Blazer Pickup GMC S15 Jimmy Sonoma 98-05 1AAuto.com

How To Install Replace 4×4 Dash Switch Chevy S10 Blazer Pickup GMC S15 Jimmy Sonoma 98-05 1AAuto.com

http://www.1aauto.com/1A/TransferCaseShiftMotor/Chevy/S10-Blazer/1AFWM00019 1A Auto shows you the procedure for replacing a broken or shorted out 4WD dash switch on a 2000 Chevrolet S10 Blazer….

20
Like
Save


Comments

1A Auto Parts says:

We currently don’t have a video that shows this particular repair.
1aauto.com 888-844-3393

John Gomes says:

I have a 1989 GMC S15 Do you have any videos that are close to showing how
to replace the dash lights I can hardly see how fast I am going at night.
Thank you for posting your how to vids.

1A Auto Parts says:

You may want to check the fuses.

1A Auto Parts says:

@Badboy4you1911 No problem bud, anytime.

Seetherwind says:

i have a problem. I have a 2003 2500HD silverado. Duramax/Allison with 137k
miles now. Just yesterday for no reason service 4WD came on when I was
driving through town in 2wd. It will not go into 4wd, the lights that light
up 2hi, 4hi, and 4lo are on but the lights right to the left of the
switches, the little round yellow ones that show which mode you are in are
not coming on at all, all are off, and the red neutral one is not on
either..Any suggestions?

1A Auto Parts says:

@JHONSONAREA51 You may want to check the actuator to see if it’s
working.Hope this helps.

JHONSONAREA51 says:

help me ! when i press low bottom tilt tilt but not keep on what could be
the problem?

Cole Oliver says:

I have 94 s10. When i press either 4wd button, both lights will flash and
there is a clicking from under the dash but it wont engage into 4×4.
Sometimes both lights will stay solid, and other times both lights will go
off and the 2wd light comes back on. Any advice?

Iguana Porquería says:

it’s not for headlights….. 4×4 switch don’t have light on 🙁

Iguana Porquería says:

yes, everything works good….. could it be the transfer case module?

Badboy4you1911 says:

@1aauto thanks tony

allhunting says:

@1aauto I removed the grill and headlight, then you can see the accuator.
when i hit 4wd the accuator sucked in slightly then slowly released, when i
hit 2wd it would suck in all the way and stayed in. it was the vaccum
switch on top of the Tcase. the ball was sticking on the switch. I replaced
it and now it works great…… thanks for the help

1A Auto Parts says:

You may want to check the switch and also the actuator to see if it’s
working correctly.

1A Auto Parts says:

If the headlights are not working, it might be a bad headlight switch.

Badboy4you1911 says:

will this trick work on 1996 chev s10

1A Auto Parts says:

You may want to check the vacuum actuator to see if it’s working correctly,
it’s common for them to stick and stop working correctly with age. We carry
new ones on our website 1aauto.com if that’s what’s causing the issue.
888-844-3393

Iguana Porquería says:

ohh ok tanxs so much. 🙂

woodpecker1337 says:

My selector switch from 2h will not blink when I switch to 4 hi I and will
not go into 4 wheel haha I but if I put it in neutral

mateo solis says:

thanks u the best…

1A Auto Parts says:

@allhunting Hmmm…Have you checked the hubs themselves to see if anything
is worn in them causing them not to stay engaged. We also sell the vacuum
solenoid, but usually if that’s bad the dash light will blink (you said
yours stays lit). Here’s a link to that solenoid on our website if you want
to see what it looks like.
1aauto.com/1A/4WDrive/Chevy/S10-Pickup/1AFWA00011/372282/2002?utm_source=youtube&utm_medium=youtube&utm_campaign=1ATony

1A Auto Parts says:

@allhunting This is also true. If you have any broke,brittle or dry rotted
vacuum lines under the hood of the truck, you should fix them as this could
also resolve the issue that you are experiencing.

mateo solis says:

my problem is the “dash light’ I replace the bulbs, check the fuse, replace
the dashboard, check the wires, what else can i do… please help…. and
thanks good videos…. solismateo82@yahoo.com

Stenchx says:

I have a 1999 Chevy blazer and I’m stuck on 4lo will switching the switch
fix the problem?

1A Auto Parts says:

HI Cole you might have a bad vacuum actuator. We have a video on this too.
If it goes bad it would prevent the truck from going into 4WD. We sell them
on our website with FREE SHIPPING Part Number: 1AFWA00002 1aauto.com
888-844-3393 Hope this helps you out. 1aauto.com

1A Auto Parts says:

@allhunting Cool…glad we could help yah out. Have a great day!

1A Auto Parts says:

If you tap the switch and it works, it could be a bad switch. We carry new
ones on 1aauto.com with free shipping. 888-844-3393

1A Auto Parts says:

@jonathanestuardo07 Thank you for checking out our Blazer dash switch video.

woodpecker1337 says:

My selector switch lights up in 2 hi if I push for 4h it neither switches
in into 4h on my nor light up up I can still go into neutral in switch to 4
wheel low please advise

Iguana Porquería says:

in my truck don’t have any light….. what do you think it’s happen?

1A Auto Parts says:

Thanks for watching. It is Part Number: 1AFWM00019 on our website
1aauto.com 888-844-3393

Write a comment