FINALLY!!!! An excellent video about the belt tensioner on a
freestar/wnidstar. NO OTHER videos on YouTube do as good a job as these
guys do! My only complaint is I could not exactly see where to put the
wrench to release tension. I don’t mind having to pull a tire to get to it
just so long as i can get to it! THANK YOU!
I have a 95 windstar and the belt puley is different to the one you show on
the 99 wind star. What is the best way to retract the puley to its original
possition. it is very hard to pull from under the van I already bent a bolt
trying to put it back.
Really handy. I wasn’t sure how to get to the tensioner if at all. BTW, you
can add Freestar to the tag line because it’s basically the same steps,
including the 4.2L engine. Thanks for the help.
Can the belt be changed alone or does the Tensioner and idler pullies both
need to be changed when the belt is changed?
FINALLY!!!! An excellent video about the belt tensioner on a
freestar/wnidstar. NO OTHER videos on YouTube do as good a job as these
guys do! My only complaint is I could not exactly see where to put the
wrench to release tension. I don’t mind having to pull a tire to get to it
just so long as i can get to it! THANK YOU!
I have a 95 windstar and the belt puley is different to the one you show on
the 99 wind star. What is the best way to retract the puley to its original
possition. it is very hard to pull from under the van I already bent a bolt
trying to put it back.
Really handy. I wasn’t sure how to get to the tensioner if at all. BTW, you
can add Freestar to the tag line because it’s basically the same steps,
including the 4.2L engine. Thanks for the help.
This is for a 3.8L engine. Tensioner in difficult place. 3.0L much easier
as it is accessible from top side engine compartment near alternator.
excellent video. very detailed.
merci merci
Will this work for a 2004?
This was very helpful. Thank you for taking the time to make this Windstar
video.
Thanks. This vid helps a lot cuz I have to change my water pump.