replacing the outer tie rod ends on my 2000 Ford Focus.
Thanks! Nice demo.
you can try using some PB blaster and a propane torch to break the rust. also make sure that your turning it the right way
been having trouble trying to get the bolt that holds the tie rod end in place … not the one that holds it to the knuckle. but the one that holds it in place on the tie rod inner.. it wont budge…no matter what I try to do
what size socket?
if you replace your tie rods the alignment will be close but not perfect. I have always had an alignment done
I’ve got the same car and mine recently went bad, I was wondering will I have to get an alignment done after I replace this?
yes it’s identical.
You must be logged in to post a comment.
){kind=link}
Thanks! Nice demo.
you can try using some PB blaster and a propane torch to break the rust. also make sure that your turning it the right way
been having trouble trying to get the bolt that holds the tie rod end in place … not the one that holds it to the knuckle. but the one that holds it in place on the tie rod inner.. it wont budge…no matter what I try to do
what size socket?
if you replace your tie rods the alignment will be close but not perfect. I have always had an alignment done
I’ve got the same car and mine recently went bad, I was wondering will I have to get an alignment done after I replace this?
yes it’s identical.