In this video, I show you how to replace the door pressure switch that turns on the dome light and other interior accessories. The process is straightforward. Using a 15mm deep socket, unbolt the nut holding the door pressure switch to the A pillar. Pull the switch forward and try to pull out as much of the wiring harness as possible. The put a clamp on the wiring harness to keep it from pulling back through inside the A pillar. remove the switch and insert the new switch. Then bolt the switch back into place. Last step is to close the door which sets the depth of the pressure switch.
#fordf150 #obsford #diy
1995 Ford F150
Bronco
🚧 Links:
– Door Pressure Switch 👉
– Green Nitrile Gloves 👉 https://www.shareasale.com/u.cfm?d=1027513&m=130989&u=3662283 click this to buy rubber gloves from Zoomget. Use coupon code: 1C10! to get 10% off 1st Choice Gloves.
⏰ Time Stamps:
0:00 Intro
0:09 What does it do?
0:27 Unbolting the switch
0:43 VERY IMPORTANT STEP
1:00 Remove original switch
1:09 Install new switch
1:19 Bolt the switch back
1:30 Is this right??
2:01 Test the switch
2:15 Conclusion
Welcome to The Minute Masters YouTube Channel where I (Stevie) show you how to repair and upgrade all Ford F series trucks and Broncos from 1980-1997. So hit that subscribe button and be ready to resurrect your baby!🤙
🔥Subscribe here: https://www.youtube.com/c/TheMinuteMasters
Links to my favorite product producers:
– https://desolatemotorsports.com/
– https://www.bubbarope.com/
– https://donttellmywiferacing.bigcartel.com/
– http://www.bajahidretrofits.com/
– https://capritools.com/
– https://rebrand.ly/minutemasters 👈 Click this to get 10% off at Olsa Tools
The project is my 1995 Ford F150 XL 2wd 8 foot bed.
🛍 As an Amazon Associate I earn from qualifying purchases.
){kind=link}
I just unscrew the jamb nut, and push them through the cab. I don’t want my dome light coming on, unless I tell it to.
However these are old habits from being in asset recovery.