How to Install Flowmaster Outlaw Exhaust 2014 Dodge Ram 1500 Hemi

How to Install Flowmaster Outlaw Exhaust 2014 Dodge Ram 1500 Hemi

Check out this wicked Outlaw Exhaust system from Flowmaster Performance. Micheal shows you how to put it on this 2014 Dodge Ram with a Hemi engine. Gains in performance, mileage and of course it adds an impressive sound!

88,778
Like
Save


Comments

Alonso Haros says:

Super 10’s are not the outlaw’s

Modded-_Vision says:

How much would something like that cost?

Ken Cook says:

Pretty detailed video enjoyed it thank you I got a 2012 ram I just had them custom built exhaust flow masters sounds bad ass check out what we built in my shop https://youtu.be/BbwuEmWyOsg thank You

Charles Dougherty says:

I have the same truck. Can I install 2 super 10 mufflers on my truck by cutting out the resonators & installing the mufflers there & putting a y pipe where the old muffler is now.

Fatboy IKE says:

Excellent video, thank you

Silentman08 says:

no need for cutting on a 2014 ram. I took mine apart and had no issue without cutting, bad advice from this newbie.

Ryan Genereux says:

any drone ??

Junior Tamati says:

How much would this cost?

James Franco says:

I couldn't tell but I think you took the resonators off is that correct

Nicholas Bachman says:

Other then being 3 inch pipe what is the benefit of the outlaw cat back vs stock duals and a 10 series? Flow master rep told me it isn't any louder and performance gains a limited to none existent?

E. Tucker says:

I currently just have the Flowmaster Super 44 series muffler on my Ram. If I were to do install this would it be much louder?

djhamelin777 says:

my only problem with Flowmaster is the exhaust clamps, otherwise the outlaw series is my favorite muffler.

deadboy600 says:

Look at 1:35….. did you puncture your frame rail with something??

Austen Morneau says:

was wondering if you knew if this setup fits on the quad cab or not?

Carlos Velez says:

I have a 2014 Ram 1500 5.7L. Stock exhaust is single output exiting just behind passenger rear wheel. I like this set-up and don't want a dual output, but want the exhaust exiting in front of passenger rear wheel like my last Ram. Do they make a set-up for this scenario? What do you reccomend? Also, what about all these truck owners now with the 'muffler delete', what would any pros or cons be with that?

Jim Goldwin says:

just installed my flowmaster outlaw exhaust on my 2013 ram sport. pretty easy except I can't get the two clamps on the drivers side pieces over the axle to tighten up over the pipe any suggestions?

Khaled Nabilsi says:

why the exhaust smoked when you installed the outlaw?

j0hnnyw987 says:

what headlights are those?

Dylan Jacobson says:

On these trucks you recommend just doing the muffler or whole cat back?

bep2001 kumar says:

maybe they change the name of it or maybe they don't even make it anymore but the muffler your putting on is actually called the super 10 series. Its a one Chamber muffler by flowmaster. The outlaw is a straight through design with tuning rings inside of it to kind of take the edge off open headers. but you can just put it as a normal muffler and it slightly changes the tone of being just completely straight pipe. but its completely straight through design without any ceramic glass packing. Now if they changed the name of this muffler your putting on to the outlaw muffler them please correct me but as far as I know it still called the super 10 series

Caleb Coronado says:

how much was all the piping and flow master ? I have a flow master 10 series and it's very loud!!

Anthony Macneil says:

Installed a Spintech Super Pro 9000 best sound I've ever heard

Virgil Jensen says:

What size are your tips?

Anthony Macneil says:

I installed a Pro Spintech Muffler best sound I've ever heard

Write a comment