https://www.1aauto.com/hood-release-cable-with-handle/i/1ahrc00052?utm_source=YouTube&utm_medium=description&utm_campaign=videodesc&utm_term=fOZ6z6xDwNk
In this video, 1A Auto shows how to replace the hood release cable on a Chrysler 300.
🔧 Instructions:
1. Removing the Bumper 0:52
2. Removing the Driver Headlight 3:26
3. Removing the Hood Release Cable 4:20
4. Installing the Hood Release Cable 8:48
5. Installing the Headlight 11:02
6. Installing the Bumper 13:10
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
){kind=link}
I have an 08 charger r/t. I simply disconnected the cord from the latch and connected it to about 8’ of welding wire. From there, I pulled the cord off the 3 locating clips. Then inside the car, I removed the handle as shown and pulled the entire cord through the firewall. Disconnect the old cord and put the new one on the wire that was also pulled through. Then pull from the engine side to have the new cable follow the path of the old one.
This avoids having to remove the bumper, wheel well, and wheel.
Good luck.
Thanks for this guy's !!
Will this hood cable fit on chrysler 300 2.7 base model ?
Thanx