The tube bolts are 8mm or 5/16 not a 9mm sorry. They both run alittle big and the next size runs small so maybe ok or “Special”? They are not on that tight. …
The tube bolts are 8mm or 5/16 not a 9mm sorry. They both run alittle big and the next size runs small so maybe ok or “Special”? They are not on that tight. …
You must be logged in to post a comment.
can you tell me how much it cost for your EGR Valve with tthe 2 gaskets
please??? Great video, very helpful indeed……
I would get both O’ring gaskets and any (metal) engine gasket also. Intake
manifold air leaks is bad. There should not be any rubber O’rings near the
engine block?
hi, I have dealership mopar parts, 05072141AA and 05161761AA, the second
part I already installed and waiting to do the first part number still. I
have no idea how these gaskets are supposed to be put on, I don’t know
which side is bottom and top. and theres a rubber piece that comes with
them and don’t know where it goes. please someone help, this is killing me,
I need my a/c.
No engine light, I just changed it because I needed to remove it for other
job. One of the oil sensors is behind the EGR valve good time to chane that
also.
easy to install, don;t get ripped by dealership
u said that u had a spit sputter problem….when u changed the egr did it
fix it? did u have a check engine light? thanks
i have a 3.5 v6 charger the egr valve looks exactly the same but is located
behind the engine. the rubber o’ring gasket on mine dried up and the tube
going in to the intake manifold keeps coming out. do I just need 1 o’ring
or two like the one in your video?
I don’t know if I stalled the one I did correctly.
Thank you :}
Whats the price of the EGR valve?
59.99 at auto zone
Go on? I had to take it off for other reasons figured I would change it out.
70 at napa
Whats the egr do cause my charger rpms go low and turn off went I stop in
traffic or stop light any ideas I need to replace the egr ?
I am not sure, I got it at the dealers.
Torque specs from the service manual: Tube to Exhaust Manifold Bolts: 31
N-m / 275 In. Lbs… EGR Valve to Cyl Head Bolts: 31 N-m / 275 In. Lbs…
Tube to EGR Valve Bolts: 11 N-m / 95 In Lbs.
when i start my 3.5 sxt charger it will idle for a few seconds then will
die. i scanned it and the only problem that came up was egr valve im pretty
sure its stuck open, would this be the cause of the problem?
Why not just do a egr delete
Thank you
there’s a rubber gasket around the valve head cover but the head gasket is
steel.
139 .00 in Canada at dealership.85.00 at car quest