Great video! I have never done this type of head and came here to figure out where the o ring went. I am going to do this job with the heads still on the vehicle by pressurizing each cylinder one at a time. my quotation is why couldn't you install the oring on the valve before you add the spring and retainer? this way it would be much easier to see the oring especially with the head still on the engine. Is there some clearance issue that won't allow that? thanks. And again great video!
6 minutes WELL spent. Thank you for helping take the mystery out of valve stem seals, umbrellas, O rings, etc.
thanks you I got the tool
where to get the tool from?
Great video! I have never done this type of head and came here to figure out where the o ring went. I am going to do this job with the heads still on the vehicle by pressurizing each cylinder one at a time. my quotation is why couldn't you install the oring on the valve before you add the spring and retainer? this way it would be much easier to see the oring especially with the head still on the engine. Is there some clearance issue that won't allow that? thanks. And again great video!
Американский рукожоп! Бухие Русские и то аккуратнее собирают..!!!
helped a lot. thank you
helped a lot. thank you
Great instructional how to video.
Very good video