How to Replace Front Exterior Door Handle 14-17 Chevy Silverado

How to Replace Front Exterior Door Handle 14-17 Chevy Silverado

Buy Now!
New Exterior Door Handle from 1AAuto.com http://1aau.to/ia/1ADHE01413

1A Auto shows you how to repair, install, fix, change or replace a broken or snapped off Exterior / Outside door handle. This video is applicable to 14, 15, 16, 17 Chevy Silverado

🔧 List of tools used:
• 7mm Socket http://1aau.to/oEB/1AXAA00017
• Ratchet http://1aau.to/oTI/1AXAA00016
• Socket Extensions http://1aau.to/oJD/1AXAA00015
• Pick http://1aau.to/oe3/1AXAA00037

For More Info visit us at http://1aau.to/h/bxi/

⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

34,345
Like
Save


Comments

1A Auto: Repair Tips & Secrets Only Mechanics Know says:

Watch the Video
Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
Do it Yourself
Save Money

Top Truckin says:

Thank you. Took me 15 minutes to do both sides. Easiest door handle swap ever

Nicholas Robinson says:

Where is the video if the bolt fell?

George Nettles Jr says:

What's that reach in door tool called?

William Owens says:

Now put it back on….getting it off is the easy part

Ty Carpenter says:

Anyone have an issue with the bolt not seating back into the door once installed. It will not fasten itself.

Peter Okafor says:

Do you know what length and diameter of the 7mm bolt for the door

Chris Sindt says:

This might be the worst design by far on a door handle. If you don't have a long handled awl (like I didn't) and you have to bend some metal rods (that are small enough to fit inside of there) then you will really have a lot of trouble with this thing. I much preferred the old design of having to take off the door panel and unscrew them from the inside. I broke the screw hole so I had to glue the other piece (with gorilla glue) back in there to make it stay. Absolute garbage is all I have to say. I would have fixed a pre 2014 door handle in about 30 minutes and this took me over an hour.

Bridgett Kellie says:

What if my previous handle was broken off and part of the mechanism next to the lock is stuck inside? Can I do it this same way or will I have to remove the whole door panel

Comments are disabled for this post.