Buy Now!
New Exterior Door Handle from 1AAuto.com http://1aau.to/ia/1ADHE00444
1A Auto shows you how to repair, install, fix, change or replace a broken or snapped off Exterior / Outside door handle. This video is applicable to the 09 Chevy Suburban
🔧 List of tools used:
• Flat Blade Screwdriver http://1aau.to/oaas/1AXAA00013
• 10mm Socket http://1aau.to/oQK/1AXAA00017
• 6mm Socket http://1aau.to/oQK/1AXAA00017
• Trim Tool Set http://1aau.to/onf/1AXXX00004
• Ratchet http://1aau.to/oabY/1AXAA00016
• Socket Extensions http://1aau.to/oW6/1AXAA00015
• Razor Blade / Gasket Scraper http://1aau.to/obF/1AXAA00280
For More Info visit us at http://1aau.to/h/a29/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
√ Do it Yourself
√ Save Money
You never have to disconnect actuator rod from the plastic rod adjuster down below the yellow piece in the video ! And most times it will break or be out of adjustment !!!!!! and you will have to replace the whole actuator if it breaks ! The handle rod slips into handle from the outside just did one ! Also there are two handles a short lever made of pot metal and a long lever handle made of plastic that slips into handle lever rod always use vin and then match up prior to install if you try to install a long lever on handle it will bind up the rod so look at the handle prior and match up by eye the dealer gave me the wrong handle but then I found out there are two models of handles !
Video is helpful, but you do skip replacing the key lock tumbler….
The 2 – 10mm bolts for the handle, what is the length? I put them in a cup and lost them
I have a question about the door panel clips. Does your company sell those? Thanks so much!
Door openers from inside but won’t open from out side handle
no detail on how to reattach the keyed lock assembly back to the lock mechanism – yeah – I pulled mine out like you showed and now can't figure out how to get it connected back.
Just did on a Escalade platinum 100% recommended
This is a great tutorial. My Tahoe's doors froze shut due to some freezing rain over night and I yanked my driver door handle right off. I paid a lot for this vehicle — why is the handle made out of plastic? This is going to save me a lot of money.
Instructions were “right” on! Mine was a broken passenger side handle (attempted theft) but the instructions were the same for the driver side for my 09 Chevy Tahoe LTZ. It took less than 20 minutes to repair. Thanks!
Thank you for this in-depth video. Now I have more beer money from doing this myself. Lol
Thanks. I wish they would make these door handles stronger. They break too easy.
Is there a video for the passenger front door? It’s completely different from the driver side door.