I show how to remove and install the front Spindles on a Chevrolet Silverado 1500. This is the same procedure if your are installing lowering Spindles. It’s also the same for a GMC Sierra as well. This should be the same procedure for 99-07 model Chevy/GMC 1500 2wd. The tire I used is a 275/70r18 bfg all terrain that is 33.2″ tall.
99-07 Chevrolet GMC Lift Spindles – https://amzn.to/3bZuRa1
As always I appreciate you watching! ~Ryan.
What are the specs on the wheels you put on that truck? I have stock 17s, but the link to the spindles you posted say no more than 4.6" backspacing and I think the stocks are 5"ish. Just curious because the wheels you have look like stock GM.
Should I run 3inch or 2inch longer shocks ?
Were can I found the 3 inch spindle.
Great video man
Do you know if you need lift control arms ? No issues with balljoints ?
I’m sure this is a dumb question, but does this mess with the alignment any?
How to raise the front height of a 2008 Chevy Uplander without changing tires or wheels safely.
If You NorCal modded that truck with the 3 in lift spindle would you be able to run 35s with no offset ??
Man thank you so much for taking the time and making this video. I have an 08 Silverado and I'm getting ready to install my 3" lift spindles but I've never done it before. Even though mines an 08, this is still very helpful. One concern I have is that I've seen people comment on the "final track width", some say 1/2", some say 1". Is it really that much of a difference? I was planning on buying 1.5" spacers for the front and 2" for the rear, that way it evens out.
Can you go In to detail in another video of how you did you abs line because I did I I keep going though abs bc it is pulling it or cutting the line with the tire
Thanks for this video helps me a lot!!!
I’ve been told I have to get different shocks when doing the spindle lift. Can someone give me a little more insight on this?