This is on a 2000 GMC. Changing a drive shaft center support bearing or carrier bearing. The truck had a vibration around 45mph that went away after this ope…
This is on a 2000 GMC. Changing a drive shaft center support bearing or carrier bearing. The truck had a vibration around 45mph that went away after this ope…
You must be logged in to post a comment.
i had to do this today on my dodge. used a vice and an air hammer to press
it out and the new one on.
THANKS FOR THE VIDEO we replaced our center bearing and it failed 2 days
later didn’t know about the double spline this video helped a lot thanks
again
Always nice to see a calm, methodical approach.
i did a rebuild on a caterpillar 950h single loader frame I had to weld the
main pin boss bushes to get them out and use liquid nitrogen to get the new
ones back in with a sledge hammer haha
Where was this when I was changing it out 5 months ago?? Lol – now
interesting thing is our carrier bearing went to crap on us again last
night with 7000 miles on it….any ideas? First time the rubber had
disintegrated – very old – knew it needed to be done. This time we were
getting a clunk noise upon acceleration from a stop…..immediately
investigated to find the career bearing had pulled itself out of the
rubber?
very cool