Buy Now!
New Wheel Bearing & Hub Assembly from 1AAuto.com http://1aau.to/ia/1ASHR00078
🔧 List of tools used:
• Flat Blade Screwdriver
• Pry Bar http://1aau.to/tax/1AXAA00020
• 15mm Socket
• 18mm Socket
• 19mm Socket
• 35mm Socket
• Hub Puller
• Pipe Wrench
• Vise Grip Pliers
• T30 Torx Bit
• 1/2 Inch Breaker Bar http://1aau.to/tbt/1AXAA00078
• Ratchet
• Socket Extensions
• Torque Wrench http://1aau.to/tek/1AXAA00044
• Center Punch http://1aau.to/tV/1AXAA00055
• Floor Jack http://1aau.to/td5/1AXAA00068
• Hammer http://1aau.to/tbM/1AXAA00091
• Jack Stands http://1aau.to/tea/1AXAA00065
For More Info visit us at https://www.1aauto.com?utm_source=YouTube&utm_medium=description&utm_campaign=videodesc&utm_term=dF_1RzCx-tg
1A Auto shows you how to repair, install, fix, change or replace a worn out, vibrating or groaning rear wheel bearing hub. This video is applicable to the 03, 04, 05, 06, 07 Cadillac CTS
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
How about on a Cadillac STS 2006? Thanks in advance
Hello – Is there a reason you are unable to mount the E-Brake plate w/ 2x 15mm Bolts before sliding the hub onto the splines? I had one hell of a time getting that plate to line up with the hub installed. Pulled it back off, got the 2 15mm bolts started, then mounted the slid the hub onto the splines and slid the ABS wire through. Much easier
Thanks man your the best couldn't have done it without you
is it better to break the tug on the hub before lifting the car up and before removing the tire wheel too??
Great video! Definitely needed the 18mm wrench. Had a hard time with rusted bolts but a torch did the trick! Also my axle bolt was a 35mm so be sure to check yours before you attempt yourself!
35mm doesn't fit mine, it's 36 mm apparently.
Great information just starting to get signs of needing this done 87,000k on my 07 CTS planning on doing in the 100k Service
Шлицы вала надо смазать…
is this the same for an STS?
nice video ……can you please show a video abt how to install back to back bearing arrangment sir
I replaced my rear hub assembly, and it still has a grinding sounds upon acceleration. Any ideas? 07 cadilllac cts.
Great Video ( You do Great
Work, And Great Explanations )
thank You Sir
great video