Review and installation of some Cadillac LED logo projection welcome lights. These custom Cadillac emblem LED lights are easy to install, and require only a flat head screwdriver for removing the original OEM puddle lamp assembly. In this video we replace the original puddle lamp assembly to the logo lights on a Cadillac XTS4 Platinum.
Cadillac logo car door courtesy lights ▶ https://amzn.to/3jNpXU2
These custom LED logo light assemblies are easy to install being a direct replacement with a plug-and-play connection. They require no vehicle modification for fitting or installation, and can be just as easily switched back to the original lights. The LED logo light will show the projection on the ground when the door is open and closed, turning off automatically once the door is shut. Check out below for model and year compatibility as well as step-by-step installation instructions.
🟠 Compatible Cadillac models
SRX: 2010-2017
XTS: 2009-2016
ATS: 2013-2017
XT4: 2018-2019
XT5: 2016-2019
XT6: 2019
🔵 Installation Instructions:
1. Use a flat head screwdriver to pry and remove, then disconnect the original light assembly.
2. Plug in the replacement logo light assembly by matching the connector and plug sides.
3. Put the new assembly with original trim piece back into the car door until it pops into place.
4. Test the light by opening and closing your vehicle door.
5. If not working, check connection is good with the connector and plug. If the logo is upside down, switch to the other projector assembly as one is for the right and one is for the left.
They recommend not leaving your door open longer than a few minutes, as the film used to project the logo light can be damaged from the increasing heat. If your film is damaged, you do have the ability to remove it allowing plain white illumination instead.
🔔 Subscribe For More Here: https://www.youtube.com/afiremedia
► Popular Videos: http://bit.ly/AFire-Popular-Videos
► All Playlists: http://bit.ly/AFire-Playlists
🌐 CONNECT:
Facebook: https://www.facebook.com/afiremedia
Instagram: https://www.instagram.com/afiremedia
Twitter: https://twitter.com/AFireMarketing
All Rights Reserved © 2021 AFire Media | Duplication, transfer or reuse of this material or excerpts thereof, is prohibited. For content use connect with @afiremedia at afiremedia.com
#cadillac #welcomelights #puddlelights #courtesylights #logolights #afire
){kind=link}
How about ct6 2017?
would these work on 02 deville??
Easy instructions – took me 5 minutes
I’m worried about installing them on my 2001 DeVille because the lights are curved surface not flat mounting. Do you think it will work or I shouldn’t try?
I don't want to damage the hazard light trims or the light any advice on smooth removal…
2000 deville?
I have a 2007 cadilliac DTS and my puddle lights are a different size and ha e a clear plastic cover that holds it in so there’s nothing to attach it to what would be a good way to secure it
Anyone know if it will fit my 2011 StS?
do they have these for the escalade?
I heard they don't last very long , anything made in China is JUNK !
I recently installed these in my 2013 ATS 3.6 and they look sweet at night.