www.bimmermerchant.com This video will discuss the Disa Valve off an 03 BMW 530i. We will focus on location, removal, Faulty conditions and replacement. Enjoy.
www.bimmermerchant.com This video will discuss the Disa Valve off an 03 BMW 530i. We will focus on location, removal, Faulty conditions and replacement. Enjoy.
You must be logged in to post a comment.
Thanks buddy this vid was on target, mine was bad also it flaps in the wind
haha I was getting p1345 and p1349 misfiring codes ruff idle hopefully this
fixes my problem.
I need a disa valve for a 2003 bmw 330i. Please message me for details.
Thank you!
Dude this is a great video and I am going I was check my BMW 525i the other
day and I had the same sound and I could not figure it out. Do you have one
for a 2002 525i. The hissing was coming out the Box portion of the DISA
Hey buddy decent video,
after watching I went ahead and checked my disa valve. It was working ok
but was pretty dirty. A little bit oily and sooty like dirty air was being
sucked in and the grit was left inside the intake manifold.
I cleaned up my disa pretty good but I noticed through the hole of my
intake manifold where the disa goes that it was very dirty in there too.
Is it really worth taking the intake manifold off and giving it a right
good clean as well? If so I will do my bit for e46 fanatics and you tube
and record a video of how to get the manifold off and clean it ….. I dont
want to do it if there is no point tho 🙂
Haven’t heard of Disa repair kits, but we do sell used disas in good
working condition.
what item fell through??
All Disas that I’ve seen have pin holder, haven’t heard of Disas with no
pin holders.
Not that we are aware of no.
Hi Thanks for the video I just removed disa valve from my 01 330ci and
there was no pin even there was no whole where for the pin are there any
possibilities that some of the disa valve come without pins just different
design? Thanks again
Thanks, Yeah, I am not sure! This one looks like there is no pin I mean,
the pin likes screw right? Is it possible to send you a picture? I know you
might have seen tons of them, but really there is no spot for a pin on that
one and I am not sure if everything is ok. Thanks, again
What could u do if something fell inside the tube where the intake goes The
holes connected to the engine anybody know
Dude thanks a lot, this really helpend out!!
A little plastic piece, about one inch
Good video! I checked my Disa valve and there is a clicking sound. I think
its needs to be repaird. Do yo sell the Disa repair kit? if so, how much?
glad we could help out. Now be sure to subscribe for future DIY videos
focusing only on bmw models.
Hi but I want to does disa valve have a vacuum pipe?