BMW 2004-2010 X3 Transfer Case Actuator & Fluid Replacement DIY (BMW E83 X3, 2004-2014 X5, 08-14 X6)

BMW 2004-2010 X3 Transfer Case Actuator & Fluid Replacement DIY (BMW E83 X3, 2004-2014 X5, 08-14 X6)

►No matter how well the xDrive system was designed, the BMW X3 transfer case actuators do fail and will need to be serviced or replaced.

There are a few BMW X3 transfer case symptoms you might notice when it begins to fail. One of the first and most glaringly obvious signs is if you’ve noticed the 4×4, ABS, brake, or all three symbols illuminate on your dash; this could be a sign that your transfer case actuator gears are starting to fail. Another symptom that’s less obvious is that you may also hear a clicking noise when putting the transmission in gear.

In this video, Mike Hidalgo doesn’t just replace the transfer case actuator gears, he begins by replacing the transfer case fluid. We recommend using only BMW transfer case fluid (DTF1) which you can find here: https://www.fcpeuro.com/products/bmw-transfer-case-fluid-83220397244

After this job is complete, you’re going to want to have the BMW X3 transfer case reset. The adaptation values will need to be reset with a laptop running BMW ISTA, or by bringing it to a dealer/shop that can do this for you.

Read this DIY on our blog: https://blog.fcpeuro.com/how-to-repair-a-bmw-transfer-case-actuator-bmw-x3-x5-x6

Shop Parts Used In This Video Here:
https://www.fcpeuro.com/products/bmw-transfer-case-actuator-repair-kit-genuine-bmw-27102413711?utm_source=youtube&utm_medium=description&utm_campaign=mps%20e83%20×3&utm_content=diy%20transfer%20case

These Parts Will Fit The Following Vehicles:

BMW X3
2004 BMW X3
2006 BMW X3
2007 BMW X3
2008 BMW X3
2009 BMW X3
2010 BMW X3

BMW X5
2004 BMW X5 3.0i
2004 BMW X5 4.4i
2004 BMW X5 4.8is
2005 BMW X5
2006 BMW X5
2007 BMW X5
2008 BMW X5
2009 BMW X5
2010 BMW X5
2011 BMW X5 xDrive35d
2011 BMW X5 M
2012 BMW X5 M
2012 BMW X5 xDrive35d
2013 BMW X5 M
2013 BMW X5 xDrive35d

BMW X6
2008 BMW X6
2009 BMW X6
2010 BMW X6
2010 BMW X6 M
2010 BMW X6 xDrive35i
2010 BMW X6 xDrive50i
2011 BMW X6 ActiveHybrid
2011 BMW X6 M
2012 BMW X6 M
2013 BMW X6 M
2014 BMW X6 M

Index:
Intro 00:00
Drain the transfer case and expose the actuator 2:50
Remove the transfer case actuator assembly 6:04
Disassemble the transfer case actuator 7:35
Reassemble the actuator 11:30
Reinstall the transfer case actuator 18:00
Refill the transfer case with fluid 19:45
Refit the transmission crossmember 20:50

SUBSCRIBE: https://hubs.ly/H0cDnfN0

Get free parts from FCP Euro:
https://www.fcpeuro.com/page/lifetime-guarantee

Follow FCP Euro on:
https://www.facebook.com/fcpeuro
https://www.instagram.com/fcpeuro/
https://twitter.com/fcpeuro
https://www.fcpeuro.com/

18,293
Like
Save


Comments

Luis G says:

What's the oil i should be buying? How bad it is if i don't reset it with a computer after?

JEAN BRITO says:

Is it necessary to reset the service interval after a tranfer case fluid change? On this e83?

Anthony Thurman says:

About to do this on my daughters x5..thanks for the thorough..lesson

casey jones says:

currently have an x5 e70 with these 4 lights on the dash with a d36a f~can message vehicles done 89000 miles could this be the cause thanks and great video

Quartz Nation says:

I was hearing the actuator clicking after turning off the car.. Before I had chance to replace the gear my x3 went into limp mode.. So I replaced the gear but now what do I do about resetting the limp mode? Or will it reset itself? Or should i push to mechanic? Please help thanks

Cleared all codes generic code reader..
Cleaned 4 speed sensors..spark plugs. camshaft/crankshaft sensors, maf and checked all fluids.. Disconnected battery for 3 days.. I'm scared to turn ignition and see the Christmas lights.. It's not even thanksgiving yet

Bob Mathew says:

Great explanations and video!!!!

2 Lime Crew says:

I just did this and saved a buttload of duckets baby! Gracias yo!

ssdtrain1 says:

GREAT JOB BRO !!!! AWESOME INSTRUCTIONS

Miguel Bravo says:

I did mine, but my gear was actually good. Still the light comes on for it. But i have an 2008 X5 4.8i

Ben Gazetti says:

what are the signs when Actuator goes bad ?

Tubby Custard says:

this is a nightmare if you only have floor jacks
my neck hurts

jaro chati says:

Trzeba jeszcze zrobić adaptacje po OBD.

Jay Hooks says:

Thanks for the video! I notice that all of the DIY transfer case actuator repair videos and forums I've seen only apply to X3 models up to 2010. I have a 2011 and the transfer case is causing me problems. Will I find the same parts in the actuator? Gears etc? Did BMW change the transfer case design from 2011 on?

theagam97 says:

This also works for E90 325xi (drive), right?

Miguel Avila says:

Gracias, me ayudo mucho

Alex J says:

Lmfao the "sike" I almost thought u were me lmfao I talk to bolts all the time

Qollins Qollo says:

very very well elaborated and explained , thank you

Studio Supreme Channel says:

Excellent baby!!!! Thank you for the video 🙂

Евгений Матвей says:

Почему она ржавая???

Comments are disabled for this post.