In this video, we should you how to remove the front bumper on the Audi A4/S4 (B9). We also show the process of removing the stock grille, for those looking to install an RS-style grille. Looking to purchase one of these grilles? Head over to our website here:
https://www.emmanueledesign.com/collections/audi/products/b9-rs4-style-black-quattro-mesh-grille?variant=2348862668829
 Bumper Removal & Grille Installation')){kind=link}
What a bullshit mod useless mod
What in the actual fuck?! This video is terrible. It skips so many imperative steps. For one, it doesn’t even address a T25 screws way into the bumper past the fender liner that have to come out in order for the bumper to come off as easily as the video portrays. Secondly, we needed an extension on the drill. Third, the terrible cinematography didn’t do us any favors in aiding the parking sensor wiring… thank god I had a buddy helping me. I couldn’t ruined the entire front of my car. Garbage.
Great video… After you took off the bumper and detach the parking sensor wires. How did you take off the Parking sensors off the original grill and mount it on to the RS grill?
Do you know the PN code of the side air intakes that are fixed internally? To be clear where the third side screw is to be screwed
I suppose these steps are going to be really similar to B9 A5? Also I would use plastic trim tools to disengage tabs to minimize scratches and surface damages, instead of screw drivers.
Could it still able to connect the parking sensors on the new RS or S grille?
Can u do it without removing te wheels?
Is there a license plate attachment or bracket for this grill if needed?
Do the same/similar instructions to remove the bumper apply to the S5 Sportback? Thanks
Is this the same grill for the B9 S5 Sportback? thanks!
One thing to remember is that you’ll also have to disconnect the wiring for the ACC radar and front camera before removing the bumper, for those who have them installed. Thanks for this video! Made installation a breeze. And the EMD bracket for the front camera mount was perfect!
There is a plastic clip you have to remove on the top part of the bonnet latch on the A4-B9 model.
I used a tiny screwdriver to pull back the plastic circlip.
You can't just pull up on the knob. I was able to vacuum grass hoppers which had gone through the grill and made a mess.
I just lifted out the top plastic piece and was able to clean behind the grill.
Thanks a lot for this video. Most helpful.
can you provide a link where we can purchase the RS type grill ? thanks