When & Where Needed: **** Raise & support the vehicle safely according to Manufacturer Jacking & Supporting Positions!!! **** Rate, Comment, Share, Subscribe…
Audi A3 (TT): Turn Signal & Hazard Switch Replacement (Part 2)
20
Like
Save
: Turn Signal & Hazard Switch Replacement (Part 2)')){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
Mine just went right back into the hole in dash when pressed. i forced it
through the last part from the front. Will this of broken the retaining
clip holding the hazard switch in? I yet to take out the stereo and the
grill at the back to get to the switches. The switch is on order
Hi there, my car has had indicator problems (but the hazards work fine)
they have stay on constant in the past and now make the ticking noise at
random points whilst driving around. Do you think replacing this switch
with a new one might solve this problem?
great vid! once the radio was out it took 5 minutes to install the hazard
switch now the blinkers are working. thanks to some research on the audi
forums i found out this is a common problem for audi’s. it went out on my
audi tt at 40k miles. thanks to this vid it helped to replace the switch.
dont delete this vid there’s no other vids showing this
good looking car inside