How to remove and replace starter; 1992-2000 Honda/Acura. Steps apply to many other year and type vehicles!
Tool List:
– socket wrench
– 8mm socket
– 10mm socket
– 12mm socket
– 14mm socket
– 3″ and 12″ extension
**If the video was helpful, remember to give it a “thumbs up” and consider subscribing. New videos every month**
Disclaimer:
Due to factors beyond the control of Engineered Mojo, I cannot guarantee against improper use or unauthorized modifications of this information. Engineered Mojo assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Engineered Mojo recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Engineered Mojo, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Engineered Mojo.
If you like the video please like and subscribe! Looking to scrounge up subscribers to spread helpful advice to and also gain some knowledge from them! Enjoy learning from my videos as much as I try to pass knowledge 🙂
Bro the best step by step video great job bro
What’s problems were you having with the car that caused you to change the starter?
cant wait for me to change my starter just so it wont fix my provide
I have 98 Acura TL 2.5 much more difficult no help here
What year starter did u get ? I have starter problem but I can’t get the right starter and already ordered the one for my car but doesn’t fit
Hey, Engineered Mojo. I appreciate the tutorial.
What is the wire loom actually for? Grounding?
By far the easiest guide ive seen
Brother thanks so much for video! It looks like my starter is not working. Yea I get a clink but no start. The battery is fairly new.
Great video
I cannot for the life of me get that bottom bolt off the starter. What sort of magic is needed for that? I've tried from the wheel well, from the passengers side above, but I keep running into AC lines or a lack of leverage…
About to go buy a mini electric impact tomorrow if I can't get it.
I wish you would have showed every step. Step by Step . Like ChrisFix videos especially the bottom bolt on the starter I wanted to know was it hard to get too and how exactly did you get to it using what extensions.
But I do Appreciate this video Bro !
And you putting and saying the bolt sizes.
where'd you buy your starter? great vid btw!
Thank you extremely helpful video
I have a 1997 Acura Integra GSR. The technique in this video does not work for my car because of the VTEC engine. The mechanics would charge 2 hours labor to replace my starter. I think that I need to remove the air intake hose, as well as the thermostat in order to get access to the starter. Any ideas?
What year is the car?
Great video man, my new starter motor is same as urs i was confused at first with that bracket but watching the video made it easy as bro thumbs up!