(This is actually the linear solenoid not the 3-4 pressure switches). This is how to remove and clean the linear solenoid on a Honda 5 speed automatic transmission. If the screens on these pressure switches are clogged they may cause slipping or shuddering so check these before you think about getting a new transmission. This applies for Honda Accord years 2003-2005 and Acura TL years 2000ish to 2006. All Honda 5 speed automatics have this solenoid but it is in a different locations sometimes.Also leave any comment down below and I will try to reply.
Did it work
Thanks for the video, man! Its appreciated!
Thank you for the video and your help. All gear shifts are great in my 2006 accord car. There is only a slight knock when going from 1 to 2. Could the problem be caused by this solenoid valve?
I want to buy an 05 TSX this is the only thing wrong with it think I could just bring the part and tools with me and put it on in the parking lot? Guy offered a discount for as is
Question bro currently dealing w an issue where the transmission jumps on the first gear and after that i can only gas under 2500 rpm or it just revs after that. The transmission basically goes in limp mode and it i have to play with the throttle to get it to move. Any clue what it might be i have a code for transmission shift solenoid P0957 P0815
Nice video.
I have a 2007 Accord with same v6 engine. I recently started having slightly delayed and harsh 1-2 shifting especially when engine is cold. It gets better when warmed up, but not best. I also noticed delayed 2-1 shifting. When slowing down, it tends to remain in 2 till I give it gas to move off, then it comes to 1. But absolutely no slipping.
Oil is good level and not burnt, no much shavings the last time it was changed.
I cleaned the solenoid, but it wasn't much dirty. Should I just change it? I don't want this harsh shifting to damage more things.
Thanks
Same thing for a 2006 Acura RSX?
I have a 2004 Accord 3.0 280;000. Trying to replace shift solenoid A. There is a bolt on top and shift solenoid B on the bottom..how do I get it out? It's halfway out but the bolt is keeping it from coming all the way out
How can I remove that solenoid cap when it is the first time that I am going to remove it since it is very stuck
Hey, great video!
Quick question. I have a 04 Accord 4-cyl auto and I’ve owned it for about 5 years. Every time I accelerate from 10-20km/h and the car is in 2nd gear (traffic) it’s like there’s a delay in acceleration and the car kind of “jumps” when the power kicks in. This happens during regular driving not hard acceleration. Really hard to explain. But I’m not sure if this will solve my problem. Any ideas?
Thanks
Shut up and just replace it….jesus
Is it the same for a 2004 Acura TSX
Is it the same for a 2004 Acura TSX
Is it the same for a 2004 Acura TSX
Great video, got it done. But my new gasket won’t seal… any help !?
Took all the bolts out the solenoid is stuck on the body wont pull up…how do i pry it off without hurting solenoid
I got the code P0777 (Shift solenoid B Control Circuit High). Do you want where that one Is located and the part number? Or where I can find that information at?
Did you flush your transmission fluid?
Hey bro I have a honda accord 04 and it kinda of shudder between 35 and 45. I just bought it, haven't changed the transmission fluid yet..I'm thinking this might be my problem too.
It’s literally just plug and play correct ?
This is my problem
What size bolts
Did it work?
Disable the VCM too! it'll save your engine!
What year, make, and model is the car in the video? I'm getting ready to do the same on mine, 1999 Honda Accord EX 6 cyl., for rough 1st-2nd gear shifting associated w rpms shooting up to 3 1/2 before 1st shift…
Dude great video
What was the main issue? Does it have anything to do with reverse not engaging?
Did it fix your problem? Have same car.