Front Brake Pads Replacement – DIY – 2015 – 2020 Acura TLX

Front Brake Pads Replacement – DIY – 2015 – 2020 Acura TLX

***!!!side-note*** hello my friends, In the video, the demonstration shows the inside pads have two shims; However, the correct one is that the outside pads have two shims. Hope the information is helpful. Thanks Y’all. Take care and stay safe!!.

Tools: 17mm wrench or socket and ratchet wrench, 19mm socket, brake caliber piston compression tool, floor jack and jackstands.

– Lisle 25750 Dual Piston Brake Caliper Compressor
https://amzn.to/3vEzToA
– Or this Brake Caliper Compression Tool
https://amzn.to/3MPsw3l
– Brake Pads Front – Acura (45022-SJP-A01)
https://amzn.to/3KQJ1uF
– pocket flashlight – bright for the small size, in case you need one
https://amzn.to/3w8jYhb

Thank you for your support. Don’t hesitate to hit like for a helpful video.

This Video shows you how to replace front brake pads on 2015 – 2020 Acura TLX.
Please refer to your owner manual and service manual for caution, safety, and specification.

Please, Leave comments and question. I will answer it to my best knowledge if I can.
Thank you for watching.

This DIY video is for demonstration purposes only. Do the work at your own risk. I do not hold any responsibility for any damages or incident during the work.
Disclaimer of Liability (No Responsibility): Due to factors beyond the control of Huu. Please exercise due diligence with information obtained from this video. The information contained in this video is for entertainment purpose and should only be treated as such. Huu assumes no liability for any property or personal damage that may arise from doing a repair on your vehicle after watching any of my repair videos. You will use such information at your own risk. Due to factors beyond the control of Huu , no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Huu recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Again, any injury, damage or loss that may result from improper use of tools, equipment, or the information contained in this video is the sole responsibility of the user and not Huu.

The videos are for entertainment purpose

10,287
Like
Save


Comments

TheTrueMotivation says:

You pad slapper mfer

Outsiders Edge says:

You never need that much grease on a brake pad this is bad video

Hard Cold says:

You are supposed to re-grease the guide pins, replace the clips, grease the clips and clean the whole assembly with a wire brush. This is why I do these myself – with the total care package, instead of paying insane amounts for the laziest jobs. No offense.

Peter Leon says:

No turning rotors and no brake clean to clean the rubber boots on the caliper?

Allen Wands Jr. says:

Thanks for posting this! I can do this (famous last words lol)

C D says:

The outside pad get two shims not the inside what works for me is taking pictures as I go on with the job

D Pepe says:

Thank you! Your tip on releasing the air on the seal saved me!

DaMon Edwards says:

Thx man for sharing this brake pad replacement task…. very appreciative!!☺

M D says:

Are you sure it’s the inner pad that gets the 2 shims?

NGUYỄN VĂN AN says:

Nói tiếng việt đi chú

Comments are disabled for this post.