Detailed step by step installation of an OE hitch and wire harness on a 2014 Acura MDX. Hitch P/N 08L92-TZ5-200 Harness P/N 08L91-TZ5-201 (or 08L91-TZ5-200)
Detailed step by step installation of an OE hitch and wire harness on a 2014 Acura MDX. Hitch P/N 08L92-TZ5-200 Harness P/N 08L91-TZ5-201 (or 08L91-TZ5-200)
You must be logged in to post a comment.
){kind=link}
Thanks for this video. I’ll be using it when I decide to purchase my own
OEM hitch. I have run into a problem with my curt aftermarket hitch for my
14 mdx. I use a full sized spare rather than a donut. After installing the
curt hitch I couldn’t hoist up my full sized spare, the curt hitch impedes
into the area where the tire goes. There isn’t a problem with the donut
going up, but since I am using a full spare, it looks like I’ll have to
move over to a donut/get an oem hitch. My question: Will a full sized spare
(19 inch tech wheel) fit underneath the car with the OEM hitch?
I just installed a hitch on my wife’s 2014 MDX and your video was a huge
help. I watched it twice before the install and then just followed the
printed instructions. Very easy to do (although I did drop a couple of the
plastic pins for the radiator/battery cover and can’t find them in the
engine abyss so I’ll have to buy more). The video is dead on for every
step. Thanks for making the job a lot easier!
Thank you for taking the time to make this video. It was very nicely done,
I love how clean and organized your installation was. I have a quick
question, when I purchased the car, the dealer only installed the trailer
hatch unit (the receiver piece) without the electrical harness and wires.
I’m wondering if it is possible for me to install them separately without
removing the receiver. Thanks.
Impressive video!!!!
great video, thank you 4 share, u r the man!
Awesome video for aspiring diy’ers. Thank you so much