Parts used linked in the description below!
Watch a full tutorial as a 2009 Chevy Avalanche will have an aftermarket set of fog lights installed in the factory location. Note that this Tahoe is the same install as a Suburban, Yukon, and Avalanche.
This video applies to Chevrolet Tahoe / Suburban / Avalanche / Yukon models for years 2007, 2008, 2009, 2010, 2011, 2012, 2013 and 2014. This video also includes dash trim and stereo removal, radio wiring, programming, and installation.
If you have any questions, leave a comment below! Be sure to like and subscribe!
Fog Light Info (Amazon Associate Paid Links):
*Lights: https://amzn.to/2UXB5n4
*Wiring Kit: https://amzn.to/2UvG0eP
—Alternative Wiring kit (more of an OEM look): https://amzn.to/3BmJvEZ
*Disclosure: As an Amazon Associate I earn from qualifying purchases*
Parts used linked in the description of the video!
ignition wire and the pin how many pin to connect you said 6 pin out there the very left u said how many pin to connect it?
I have a 2015 Chevy Tahoe and am wondering if that "power" panel under the dash is similar? I am looking for a power source for the switch. Thank you in advance.
Huge help..in description where u have the Amazon info to get parts/harness..I don't see the info on the female wire from harness to light..iv been looking and can't find that one your using..thanks..
Horrible, doesn’t show at all how to remove the lights!
Where do i find that switcht and harness kit?
Just what I was looking for my 2012 Tahoe LS
I’m sorry where did you get the fog light Kit from ?
Great video, very detailed !
Would you do a video on installing HID headlights and fog lights on that truck, plz
If I pick up a factory switch, is there a way to cut the cheap ON/OFF switch, strip the wires and tie into the Factory one
That ignition pin you used was a constant 12v for my truck. 07 avalanche, i figured they'd be the same. But if anyone with an avalanche is looking for a switched 12v. I tapped the pink wire on the harness 4 blocks up from the bottom right. I want to say there were 3 wires on it pink brown and a stripped pink wire
Why didn't you use the factory fog light switch?
How you connect to the ignition box?
I get power in the button but when I turn it on I just hear a noise and they don’t turn on
I followed the steps in this video and I’m not getting any power. What could it be?
Thank you! You made the video that I was looking for. I installed my fog ligths on my 1500 silverado 2008.
Me myself. I just straight wire them so they come with the headlights
Can you put then link we're I can buy all the wiring harness
Don't those vehicles come with fog lights already installed? Why do you have to run a new sets of wire and switch?
I did the install with out relay and hard wiring, i just replace the lights switch and ran the wires from the fuse box. Everything is preinstalled on nnbs 07-13 silverado
All u have to do is run the wires from the fuse box to the fog lights
nice work broi will give thumb up , but this is not the OEM way becuse wiring only will be engine side nothing to do inside car just change the old switch with one with fog light switch.
can't you run that white ignition "trigger" wire to the factory switch so you can bypass that cheap looking Walmart fog light on off switch..? I'm in the process of trying to figure out how to put fog lights in my 2011 Tahoe using the factory switch…