IG: @c.delucia
DIY: How to change the rear brake pads and rotors on a 2010 Audi A4 using the Vag Com cable. This is a detailed video on all the steps of doing a brake pad and rotor replacement and how to use the Vag Com. Links to all parts are below ⬇⬇
@c.delucia
➡ Front Rotors: https://goo.gl/yNH2hZ
➡ Rear Rotors: https://goo.gl/fXWKKp
➡ Front Pads: https://goo.gl/aahLVE
➡ Rear Pads: https://goo.gl/a5AaBQ
➡ Pad Wear Sensor: https://goo.gl/oa4mE3
www.Ross-Tech.com
Helpful video, thank you for posting but FYI you do not need to remove the rear brake caliper carrier to remove the rotor. There is enough clearance to slide the rotor out from (and in) under the carrier. Will save a good bit of time.
Do you need to keep ignition on the whole time ?
hey are the rear brakes on these 300mm? or 330mm?
Just about to attempt this!
Thanks for the video. Do you know if the Vagcom Lite version will allow you to retract the EPB or do I need to buy the full version?
Great video. Doing rears soon. Screw driver with leverage to push piston in before removing calipar saves some time/ effort. Worth a try next time. Thanks for upload.
What are the torque specs for those bolts?
Good video but I would have liked to see you take off the lower bracket bolt on passenger side, as I was unable to get a socket on it when I attempted it. I guess there is also a torx or triple square on those bolts?