Car Fix DIY Videos

@mikechiodetti4482 says:

When's he gonna put together?

@اكرمصلاح-ف5س says:

جير فاشل جداً جداً

@alainngeufack4647 says:

I have nissan juke cvt not changing

@contendingforthefaith9897 says:

I need my 2013 nissan Pathfinder CVT overhauled/rebuilt like yesterday, 106,000 miles.

@rexytyplay5679 says:

Hi I have one doubt about cvt transmission Is the mitsubishi lancer 2008 cvt compatible with the nissan cvt cause the both made by jatco i'ts just a question that pass on my mind?

@aligeoff.27 says:

From an engineering point of view, an all steel CVT is a seriously flawed concept. It relies of there being sufficient friction between the belt and pulley to transmit the power but not so much as to create heat and wear. Engineers normally use oil to reduce friction to a minimum so in a CVT achieving the required static friction is a delicate balancing act which relies on precise thrust pressures and very specific oil specifications. Any drive relying on metal to metal friction will inevitably have a shorter life than the rolling action in a set of epicyclic gears. If you scrap an otherwise good car early because the cost of replacing a CVT makes it uneconomical to repair, how it this eco-friendly? CVTs may be smaller, lighter and cheaper to make, and give small fuel economies, great for the manufacturer, but I cannot see that they are cheaper in terms of vehicle lifetime costs.

@martinnali8104 says:

This is not overhaul, this was just disassembly. No parts were repaired or exchanged. We don’t know if this was thrown into the garbage bin.