How to Replace Front CV Axle Assembly 2004-2015 Nissan Titan

How to Replace Front CV Axle Assembly 2004-2015 Nissan Titan

Buy Now!
New CV Axle Assembly from

This video shows you how to install new Front CV Axle Assembly in your 2004-2015 Nissan Titan. A CV axle has flexible joints. Often, these joints wear out, or seize from contaminants due to the protective boot tearing open. A worn joint is prone to breakage, or other hazards. If your vehicle needs a new CV axle, install a quality TRQ axle that is engineered to your vehicle’s specifications.

This process should be similar on the following vehicles:
2004 Nissan Titan
2005 Nissan Titan
2006 Nissan Titan
2007 Nissan Titan
2008 Nissan Titan
2009 Nissan Titan
2010 Nissan Titan
2011 Nissan Titan
2012 Nissan Titan
2013 Nissan Titan
2014 Nissan Titan
2015 Nissan Titan

Tools you will need:
• Pry Bar
• 14mm Socket
• 21mm Socket
• Brake Caliper Compressor Tool. Dual Piston. Pump Style.
• Brake Caliper Hanger
• Ratchet
• Torque Wrench
• Brake Grease
• Brake Parts Cleaner
• Cloth Rags
• Liquid Thread Locker
• Floor Jack
• Jack Stands


While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.



TRQ says:

√ Watch the Video
√ Buy The Part at 1A Auto
√ Do it Yourself
√ Save Money

Good Day to Thrive says:

I took some notes that might be helpful for someone:
21mm 32mm cotter pins 22mm tie rod Pb blaster
19mm strut bottom
14mm top strut
Crowbar for strut top
14mm cv axle hammer for removal
Abs wire
Upper ball join 21mm hammer
Wire brush differential
–Copper never seize cv axle splines and diff
Upper ball join attach, reattach to diff
Torque to 54 ft lbs
58 lbs ball joint cotter pin
Abs connect to frame
Strut reconnect 3 bolts top
Bottom strut jack up control arm, hand tighten nut
22lbs strut top 3 nuts
99 lbs bottom strut nut
Sway bar 17mm wrench 19 socket
Outer tie rod 63lbs
Have someone step on brake or put bar or large screwdriver against rotor rest against top break caliper
101 lbs hub nut cotter pin
Remove safety lug nut
97lbs wheel

Comments are disabled for this post.