How to Replace Lower Control Arm 2007-2015 Mazda CX-9

How to Replace Lower Control Arm 2007-2015 Mazda CX-9

Buy Now!
New Control Arm with Ball Joint from

This video shows you how to install a new quality TRQ lower control arm with ball joint in your 2007-2015 Mazda CX-9. Control arms are a crucial part of the suspension system of your vehicle. They not only carry the load of the vehicle to the wheel, but they typically also maintain its alignment. Control arms are typically large and strong, so you may be surprised it needs replacing. They contain rubber bushings for smoother rides at the cost of eventual wear, or integrated ball joints that require replacing the entire arm when they wear.

This process should be similar on the following vehicles:
2007 Mazda CX-9
2008 Mazda CX-9
2009 Mazda CX-9
2010 Mazda CX-9
2011 Mazda CX-9
2012 Mazda CX-9
2013 Mazda CX-9
2014 Mazda CX-9
2015 Mazda CX-9

Tools you will need:
• Pry Bar
• 14mm Wrench
• 14mm Socket
• 17mm Socket
• 18mm Socket
• 21mm Socket
• Locking Pliers
• Needle nose pliers
• Needle nose pliers
• Straight Cutters
• 1/2 Inch Impact Gun
• Ratchet
• Socket Driver
• Socket Extensions
• Swivel
• Torque Wrench
• Floor Jack
• Hammer
• Jack Stands
• Wheel Chocks


While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.



@TRQ says:

√ Watch the Video
√ Buy The Part at 1A Auto
√ Do it Yourself
√ Save Money

@alexandermorales1703 says:

What gun is the

@konradjaworski3222 says:

Bro crossthreaded tf out of those welded frame nuts

@jamesthornley5185 says:

You do not have to remove the tie rod end at all in order to do the lower control arm but great details

@barry8462 says:

My daughters Mazda needs this repair. What is the average cost parts and labor?

@beaviskornholio2754 says:

Do you have a video for the front sway bar bushings for this model

Comments are disabled for this post.