Easy way to put in rockers on sohc 2.3 2.5 Lima engines
Did you put the whole lifter to match the one in the hole you put the lifters in
Make sure you Use a dead blow everyone❗️
Hes using a rubber hammer people chill
What does it mean that the cam doesn't come up? You are suppose to turn the cam so the lobe is pointed upward when installing each follower, and there is a tool used to compress the valve to make the install very easy and without a damaging hammer.
this was actually very helpful thanks
Turn the cam to move the lobe
Orrrr, use the special tool.
Prolly a dumb question but I do need to pull my engine to get the cam out of my 96 b2300
Good way to bend that valve stem.
Thanks i did not realize it was this easy.
Comments are disabled for this post.
){kind=link}
Did you put the whole lifter to match the one in the hole you put the lifters in
Make sure you Use a dead blow everyone❗️
Hes using a rubber hammer people chill
What does it mean that the cam doesn't come up? You are suppose to turn the cam so the lobe is pointed upward when installing each follower, and there is a tool used to compress the valve to make the install very easy and without a damaging hammer.
this was actually very helpful thanks
Turn the cam to move the lobe
Orrrr, use the special tool.
Prolly a dumb question but I do need to pull my engine to get the cam out of my 96 b2300
Good way to bend that valve stem.
Thanks i did not realize it was this easy.