Infiniti G35 how to program a used replacement BCM using Launch X431 IMMO Plus

Infiniti G35 how to program a used replacement BCM using Launch X431 IMMO Plus

Infiniti G35 how to program a used replacement BCM using Launch X431 IMMO Plus. BCM was replaced because the Car was a No crank, No start due to water getting into the Body Control Module. We also installed a steering lock emulator during the process. #mechanic #locksmith #nissan #carhacks
Launch X431 IMMO Plus Key Program and Diagnostic tool
*Check it out here! https://amzn.to/3V4iz8u

22,579
Like
Save


Comments

@ADVANCEDLEVELAUTO says:

Launch X431 IMMO Plus Key Program and Diagnostic tool
*Check it out here! https://amzn.to/3V4iz8u

@allenc1091 says:

DO NOT BUY THIS SCAN TOOL!!! Launch does not inform you that you need an account with NASTF in order to do this. Whxih is costly and you need a bunch of credentials..

Not the video posters fault. Launch just started doing this earlier this year. Sucks…

@mfg_c.lowk661 says:

Where you located I need this job done how much ?

@Andrew-o7j2x says:

Hey where you located?

@michaelgadson1392 says:

It's asking for a pin

@curruptedquikz250 says:

i have a infinity g35S 2008 , honestly been struggling for so long trying to find what’s wrong with the car , but long story short my brother and i were putting a sound system and when he tried unplugging the battery he accidentally touched both terminals with the ratchet .
Any idea what could be my issue ?

@JeremiahJoelHarry says:

Was the salvage yard bcm paired with the old key during this ?

@kelseyreid5793 says:

What if mechanical locks work fine and passenger keyless entry is fine? Driver works if I push really hard. Failing BCM still?

@zenbran says:

do you think/know if this tool would work with a 2007 nissan murano? For replacing the bcm

@ДимонД-я2й says:

this is old key?

@BenardBenson1 says:

Thank you, sir

@umsohood1 says:

So I took everything apart and check the bcm on mines and it’s fine no water damage and I cleaned all my grounds but my cluster still doesn’t work I get a few lights on like battery air bag and brake light everything is functioning properly tho my car is a 6mt so I don’t have a shift lock problem what do you think it could be also none of my illumination lights light up no signal indicators I do have a triple meter code and a meter code can communication code

@andydiaz7674 says:

Where did you buy the emulator I found one on eBay but takes a whole month to ship from another country pls send link

Comments are disabled for this post.