Car Fix DIY Videos

The video shows how to remove and reinstall the rear engine support mount (also known as Transaxle Rear Support Insulator) on the following 2nd generation Ford Escape vehicles equipped with a 2.5L FWD engine .

2008 Ford Escape
2009 Ford Escape
2010 Ford Escape
2011 Ford Escape
2012 Ford Escape

I replaced the 15-year-old factory-installed rear engine mount because of vibrations and a clunking noise. I noticed the clunking sound when shifting from Park to Reverse and then to Drive. Please note that it is recommended to replace the front engine mount at the same time as the rear mount.

Tools required:
• 3/8 Universal Joint
CRAFTSMAN join socket set — https://amzn.to/433ozBT
• 3/8 24 Inch Extension – Tekton – https://amzn.to/3GwC9Gi
• 15 mm (both Shallow and Deep) sockets
• 18 mm Deep socket – Craftsman – https://amzn.to/43eCq9y
• 3/8 Ratchet
• 3/8 Breaker Bar
• Penetrating Oil
PB Blaster — https://amzn.to/4jUPTJa

Parts:
• Motorcraft Part number: 5L8Z6068AE

#diymechanics #mechanic #ford #fordescape

Disclaimer: The information provided in this video and description is for informational purposes only. Please use your judgment and proceed at your own risk. The author or publisher of the video assumes no liability for any damage or injury caused by following the information provided. Please remember that when working on any DIY project, you bear all the risks alone. Seek professional assistance if you are uncertain about your ability to perform the work.