So I pulled the ABS module, reflowed the solder on the joints to attempt a repair then refitted it. Did it work?
So I pulled the ABS module, reflowed the solder on the joints to attempt a repair then refitted it. Did it work?
Comments are disabled for this post.
Well, in one car I have V70 2.5i 144 CV the ABS failure is on and off. It is not a fix failure. First I was thinking it could be the ABS control module. But checking the conector 4+21 pins, I notice that tapping on the conector the ABS light went OFF. So I suggest to recheck that conector and put something to increase presure in order to mantain a better contact between Cable Conector and Zocale conection to ABS control Module. No need to remove it. Just clean the contacts and fasten it back.
You fn butchered it with the fn sawzall blade dumb fuck!
The title to this video is misleading. Should say failed fix!.. 16 minuets of my life that I wish I could get back
I have the problem in my c70 2.4t 2001, when i check it in my computer its tells the relay pomp abs…but I don't understand where is the problem
ecu–component scanner-video-2
https://www.youtube.com/watch?v=ZzLz6inI8Pg
I would get a scanner that is designed for ABS. It looks to me that it is a wheel bearing. Usually the front one.
Having same issue BMW X5,i start car no lights ,if a sit a while or start to go ASAP,light goes on 4×4 dsc stability inactive check codes after couple minutes ,dsc sensor supply,not sure what it could be ,sensor on module or yaw sensor or abs module rebuild or speed sensors,check speed sensor check on scan show normal.turn off car wait couple minutes start and no 4×4 dsc inactive light,also dsc button works when starting the car ,not after light goes of
i have Toyota land cruiser 2007 & there is fault code c1249 brake light switch open circuit. brake light working fine & there is two wire on abs control unit found 12volt while applying the brake pedals. all the connectors are good no corrosion. can u please suggest me what problem could be there, i have doubt on a control unit. all the power and ground circuit are ok.
Abs module parts address are mail pls
does it can be with 2010 volvo xc60?
Just done and seems ok now , Speedo and abs working …but god damm you need a steady hand and good eyes !
Oh! You succeeded to fix it. Congratulations. I also have to try it.
Following the road test has the ABS light behaved itself since this video?
Well the most volvos needs 3 foulty free starts to get the lights and the code to go away.. Mine V70 -97 needed only 2 but the lights went off and the faulty code went away as well. and yes there are a silicon layer on 90 of 100 ABS modules.
So ??? Did it work for you finaly ??
Dear Santa, this year Steve would like a Dremel please 🙂
Normally to clear an old error on ABS you have to drive it so it picks up the movement on the hub, then the light goes out and resets the fault. Of course it just might not be fixed still.
Also using a OBD II to USB hooked up to your phone and clear the codes if your reader can't see all of them ( some don't .)