http://www.1aauto.com/1A/HeadLights/Toyota/Tundra/1ALHT00032 1A Auto shows you how to repair, install, fix, change or replace the broken, damaged, cracked, f…
How To Install Replace Headlights and Bulbs Toyota Tundra 00-04 1AAuto.com
65
Like
Save
){kind=link}
- Tags:
0004, 1AAuto.com, bulbs, Headlights, Install, replace, Toyota, Tundra
- Categories: Toyota
Comments
Write a comment
You must be logged in to post a comment.
Thanks so much for posting this. Had my lamp replaced in 15 mins :)
Brother, I have an 02. The signal lights have a short (I think) Light stays
on on dash (visible when night lights are on) and when I use it, (the left
blinker) it causes all interior dash lights-clock too to flash. At night,
the signal light is always lit and when it flashes, it is very weak. I
don’t have an issue with right turn signals…all bulbs work. I tried
replacing the signal relay, switch (in column) and still no remedy. Can you
offer a suggestion? I skunked! Thanks!!
Thanks for posting this, it was really helpful
;0
Hi, Thank you for the video! I was stuck when all I had was the
descriptions I’d read, until I saw you do the work. After seeing it done, I
went & successfully replaced both of my front headlights & it was real
easy! The light from the new ones is much better! I have a 2003 Tundra.
Thank you, again!
thankyou very much!!! all your videos help me so much!
Thanks for video – replacements went flawlessly. All tips were useful.
is it possible to do this on an 08? they changed the assembly and it looks
like you cant get to it without breaking a few pins/buttons
Thank you, this was easy.
Thanks for watching. 1aauto.com 888-844-3393 FREE SHIPPING in the lower 48
states.
We currently do not have an auto repair video for this particular repair.
However if you remove the two screws from the top of the headlight, then
remove the two bolts from the end of the small panel under the headlight.
This looks like it will allow you to access the remaining two bolts that
hold the headlight into place. Hope this helps you out. 1aauto.com
888-844-3393
ty so much u guys always save me
You’re welcome. Have a great day. 1aauto.com
super helpful!
cool video, thanks.
There should be an adjusting screw on the back of the headlight housing.
Cool videos. Thanks!
@BassMaster486 You’re welcome. Thank you for visiting our YouTube auto
repair channel.
Great video, saved me tons! One point though. The little plastic screw
insert, (at 3:50 of the video) is easily stripped, (especially if it is
old). It is just plastic. After you buy your headlights at 1aauto, go to
the dealer and get two of these plastic screw inserts, (88 cents each).
That way, if you destroy your plastic screw inserts, (like I did), no
worries, the new ones just pop right in. These are awesome lights.
How do you adjust them?
Thanks, very helpful!
@RedNeckk8 Thank you for checking out our auto repair channel on YouTube.