Car Fix DIY Videos

2032 Battery you need – https://amzn.to/2ZviL1d

Condition Pre-Owned / New Key 307Ho4
FCC ID KBRTS003
Part#

IC: 2119-TS003 MODEL TS003 or TS006 ETC094LP00190 DEALER PART# 3717264J00 Calsonic Kansei Corp
Dealer part # 37172-64J00
Buttons 3: Lock, Unlock, Panic / New Uncut Key
Frequency 315 MHz / Red LED Light
Battery Type 1: CR2032

2012 Suzuki Grand Vitara
2012 Suzuki SX4
2011 Suzuki Grand Vitara
2011 Suzuki SX4
2010 Suzuki Grand Vitara
2010 Suzuki SX4
2009 Suzuki Grand Vitara
2009 Suzuki SX4
2008 Suzuki Grand Vitara
2008 Suzuki SX4
2007 Suzuki Grand Vitara
2007 Suzuki SX4
2006 Suzuki Grand Vitara
2006 Suzuki SX4

REMOTE PROGRAMMING:

…………….
Method#1:
…………….

1 Sit in driver’s seat. Close all doors and ensure all doors are unlocked.
2 Insert key into ignition lock cylinder (do not turn at this time).
(the next three steps must be done within 25 seconds).
3.Push the manual lock on the driver’s door to lock, then unlock three timesm then to lock position again. (this is the lock button at the inside door release handlem NOT the power door lock switch). Lock, unlock, lock, unlock, lock, unlock, lock.
4.Pull the key out of the lock cylinder and back in four times. Out, in, out, in, out, in, out, in. (when you do this, be sure to push the key all the way in and pull the key all the way out; be methodical, not speedy. 25 seconds is a lot of time.
5. Immediately after step four, start the engine. Count three seconds, then turn off the ignition-DO NOT REMOVE THE KEY! At this point, if you have been sucessful, you will hear two audible “beeps”, the door locks will cycle and you are now in programming mode.
6. Push and hold either the lock or unlock button on the remote to be programmed. The locks will again cycle indicating the remote was sucessfully programmed. Repeat step 6 for all other remotes. Once all remotes are programmed, open and close the door, then test each remote for function. You may also remove the key at this point

……………………..
Method #2 and key cutting:
………………………

Programming: This remote control requires diagnostic programming available at your local qualified automotive locksmith. Please contact your programming source prior to purchase to be certain they have the proper diagnostic tools to program this remote to your vehicle.

3 Steps:

1. The valet key must be cut by a qualified automotive locksmith to match your vehicle’s ignition

2. The remote must be programmed by a qualified automotive locksmith to your vehicle’s installed RKE system.

3. The transponder chip (contained on the remote circuit board) must be programmed by a qualified automotive locksmith to sync with your vehicle’s immobilizer to start your engine.