Amazon link for the lights https://amzn.to/2X6Xb37
Amazon link for the wire kit https://amzn.to/2NrT3tA
As an Amazon Associate, I earn from qualifying purchases.
I installed some Amazon Led driving/fog lights on my Subaru 2016 Outback. I show how I ran my wires with an aftermarket light wire harness. Putting the switch past the firewall was the hardest part but not impossible if careful.
Disclaimer: Some of these links go to one of my websites and some are affiliate links where I’ll earn a small commission if you make a purchase at no additional cost to you.
){kind=link}
Hey I know you did this for years ago but wonder if you had battery problem with that red light always on? I just installed lights on my outback and have the same issue. The lights came with wiring harness and can only hook them up one way and followed directions to the T.
Would this be the same install instructions for a forester in the same gen, I have a 13. I’m having a hard time seeing where the wires from engine bay would enter the cabin, thanks!
Did it end up killing your battery like you thought
Nice….but I do not understand why you have your entire vehicle outfitted for off road, yet run stock tires and wheels. All seasons don't cut it off road. Why no AT tires ??
Thanks for sharing your install. Did you consider placing the switch in one of those blank switch plates to the left of the steering wheel? If so, why didn’t you go that way? Would have been cleaner I thought but probably harder I guess.
I just checked out all your vids. Great Job!!! I have one question. If i went about the same route as you what size light bar would fit? Was thinking about getting a lightbar and relocating the license plate with the tow hook holder. What do you think? Thanks
looks great man, next try some LED low beams, and fogs, game changers..