Car Fix DIY Videos

When to Replace Brake Pads on a 2024 Subaru Outback
Your brake system is designed to last for many miles around Midvale before you need to replace them. However, to ensure your brakes are working properly, it’s recommended that you or a service technician inspect the brakes every 12,000 to 15,000 miles, or 12 to 15 months, depending on your driving style. Generally, replacing the brake pads on your 2024 Subaru Outback should happen every 30,000 to 70,000 miles as the lining wears down and becomes thinner.

How to Remove Subaru Brake Pads
Replacing the brake pads on a 2024 Subaru Outback may seem like a daunting task, but it can be done at your home near South Jordan with the proper time and care. You’ll need gloves, a tire iron, a ratchet and socket set, a brake tool, a car jack, and jack stands. Note: It’s recommended that you disconnect the battery before performing any brake pad service. If you’re unfamiliar with the process, schedule a service at your Subaru dealer for brake pad replacement.

Follow these steps when replacing the brake pads on a Subaru Outback:

First, loosen the lug nuts on the wheel while the vehicle is on the ground. Then, raise the vehicle high enough to comfortably reach the brake pads and rest the vehicle on jack stands.
Take off the appropriate wheels and tires using a tire iron, and you’ll see the brake rotor and caliper assembly. If the caliper isn’t easy to access, try turning the wheel left or right for better access. Locate the bolts on the interior side of the caliper assembly and use a ratchet and socket to remove them. Ensure the brake line stays connected, and rest the caliper on top of the rotor while you work.
Pay close attention to the position of the brake pads and remove them from both sides of the rotor. If the clips holding the brake pads in place are damaged, you can use the clips that come with our new brake pads in their place.
Before installing the new brake pads, you’ll need to prepare them with brake grease and a brake cleaner, if specified by the manufacturer. Apply brake grease to the metal plates on the back of the new brake pads. Typically, a dime-sized amount is enough. Place the new brake pads in the same position as the old ones. Your vehicle’s owner’s manual should outline the correct placement.
To adjust the caliper assembly to fit your new brakes, you’ll need a brake tool. Take your old brake pads and place them inside the caliper assembly, position it against the circular piston, and tighten them against the old brake pads. Continue until you have a secure, firm fit. This allows the caliper assembly to fit over your new brake pads. Place the caliper assembly back in its original position and tighten the bolts by hand. Use a socket wrench to tighten the rest of the way.
You’re now ready to reinstall the tire. Put the tire back on, tighten the lug nuts by hand, and use the car jack to lower the vehicle to the ground. Once the vehicle is level, use the tire iron to finish tightening the lug nuts. Repeat the step above as needed for the other brakes on your vehicle.