How to Replace Saab 9-3 Door Mirror | WITHOUT Removing Door Casing

How to Replace Saab 9-3 Door Mirror | WITHOUT Removing Door Casing

How YOU can replace Saab 9-3 door mirror | SAAB 9-3ss, SAAB 9-5 & SAAB 9-3X, 03MY on
Change mirror Saab 9-3 | replace Saab 9-5 mirror
📽 Saab door mirror glass replacement: https://youtu.be/bEFaKQJV7vw
Solve water leaks, wind noise, breakages, corrosion

💡 Don’t forget to subscribe and hit that bell 🔔 to learn more about looking after your car:
https://youtube.com/channel/UC-C_1iVg6Po5xX-sHMhKANQsub_confirmation=1

💚 If you got some VALUE from this video, PLEASE give it a ‘like’ and maybe consider showing your appreciation by buying me a coffee: http://paypal.me/cyclonecyd

🎥 Saab 9-3 mirror cover & motor removal
https://www.youtube.com/watch?v=0Tik6s2kRr4&t=39s
🎥 Saab 9-3 side mirror glass replacement
https://youtu.be/bEFaKQJV7vw

TOOLS:
Torx key set
https://bit.ly/Torx_key_set
Torx bit set
https://bit.ly/Torx_bit_set
Size 6mm ratchet spanner is hard to get, but available from here
https://bit.ly/Ratchet_Spanners

🎥 How to remove & replace the rear lights and bulbs on your Saab 9-3:
https://www.youtube.com/watch?v=jrJyAlZMcMU
🎥 How to reset your Saab’s “time for service” message yourself:
https://www.youtube.com/watch?v=mORIbqE6mp0
🎥 Why not explore my entire Saab 9-3 playlist:
https://www.youtube.com/playlist?list=PLOaePmzqZNJ0gdSMQ5ihHdysTVF2otBoX
🎥 Crank sensor failure is such a common issue. Learn to recognise the symptoms:
https://www.youtube.com/watch?v=iLKOqCS67xM&t=116s

Sealant applicator gun:
bit.ly/Applicator_gun
Spare nozzles for your sealant tubes:
bit.ly/spare_nozzles
Leak sealing duct tape
bit.ly/Leak_seal_tape
Dummy shark fin in case yours is looking tired:
bit.ly/dummy_fin

Learn more about looking after your car:
🎥 How to replace a CV [constant velocity] joint boot with a split kit:
https://www.youtube.com/watch?v=MuEgTqUCBDI
🎥 Don’t let your fuel filter end up like this:
https://www.youtube.com/watch?v=8aZLTbG993Y&list=PLOaePmzqZNJ2NXFKr8wIH2-OePIUQYvGV&index=2&t=1s

Everyone should have a tyre pressure gauge in their glovebox:
http://bit.ly/Tyre_press_guage
http://bit.ly/Pressure_Gauge_2
I personally prefer a stirrup pump to a foot pump (I use the same one for my bikes and cars)
http://bit.ly/Tyre_stirrup_pump
If you’d like to learn about the science and engineering of cars:
Bosch Automotive Handbook:
https://amzn.to/39va9xA

Thank you

2,125
Like
Save


Comments

Rad Boo says:

Very nice and detailed explanation and procedure

RagnarTheRed says:

Huh, this is gonna speed things up significantly whenever I get to painting the side mirror base. Thank you!

Colin Parks says:

How do. I get the cap off the back without breaking the glass!!

Trejos says:

Just what I needed, planning to repair the aluminium shield corrosion soon which is very common on these.

Kent B says:

Whats is the extra piece of foam on the dashboard side covers? Is it for sound deadening?

Chris Ed says:

Nice Cyd. All good to know just in case. Keep up the good work.

Comments are disabled for this post.