How to fix a bad cold Idle in the Porsche 3.2 Carrera! (DIY)

How to fix a bad cold Idle in the Porsche 3.2 Carrera! (DIY)

Hi Everyone,

The cold Idle on our 1986 Porsche 3.2 Carrera has been getting worse so I wanted to get into that and see if we could get that sorted. The idle is fine when warm, but the car could run smoother, but cold it is lobey and rough. There are several bits to the Motronic fuel injection system, but only a few that are specific to cold starts. In this video I run you through my journey to find our offending part.

Tools and parts:

• HFS Carburetor Carb Valve Fuel Pump Pressure & Vacuum Tester Gauge Test Kit https://goo.gl/xtoi9r
• Small Multimeter: Velleman DVM850BL-VP Digital Multimeter with Backlight and Protective Holster, 3-1/2 Digit, 5.4″ H x 2.7″ W x 1.2″ D https://goo.gl/GVs26k
• Driew Double Ended Leads Test Clips Crocodile Alligator Jumper Lead Set Alligator Clips Connector 10 pcs Pack (50cm,5 colors) https://goo.gl/YNaDuk
• Various tools to remove parts and such.

We hope you enjoyed the video. If you did, please give it a “Thumbs up” and Subscribe to Heidi and Franny’s Garage for more videos to come. Also, click the little “Bell” by the Subscribe button to get notified when we release new videos.

We do lots of types of videos on this channel: Vlogs, How To/Hacks/DYI, Travel, Events, etc. Check out some of the other videos we have on our channel.

Thanks so much for watching!

The Cameras and Equipment we use:

Main Shooter:
Panasonic Lumix G85 (https://goo.gl/geSFpN)
Main Shooter Lens: (https://goo.gl/RsHkkF)

Car Cameras:
Sony FDR-X3000 (https://goo.gl/P6XdYZ)
GoPro Hero 5 black (https://goo.gl/kjjr31)

Car Mounts:
Fat Gecko Camera and Camcorder Mount (https://goo.gl/zqCHvT)
Fat Gecko Camera Mount (https://goo.gl/AXQAr6)
Fat Gecko Mount (https://goo.gl/RhyXYT)

Drone:
DJI Mavic Pro and Kit (https://goo.gl/jQbk9V)

Stabilizer for mobile phones and action cams:
DJI Phone Camera Gimbal OSMO MOBILE, Black (https://goo.gl/Acr1jg)

Music in video:

Local Forecast by Kevin MacLeod is licensed under a Creative Commons Attribution license (https://creativecommons.org/licenses/by/4.0/)
Source: http://incompetech.com/music/royalty-free/index.html?isrc=USUAN1300010
Artist: http://incompetech.com/

Special thanks to:

Chung Dha: (https://www.youtube.com/user/chungdha )

For his Great Adobe Premiere Presets!

Music in the video:

Song: Ikson – Wander (Vlog No Copyright Music)
Music promoted by Vlog No Copyright Music.
Video Link: https://youtu.be/xUzMJDb-3UU

Music in bumper provided by:

BACK IN SUMMER by Nicolai Heidlas Music https://soundcloud.com/nicolai-heidlas
Creative Commons — Attribution 3.0 Unported— CC BY 3.0
http://creativecommons.org/licenses/b…
Music provided by Audio Library https://youtu.be/sGsC98vR4Q4

Thanks for the awesome music!!

Heidi and Franny’s Garage.

Disclaimer:
Due to factors beyond the control of “Heidi and Franny’s Garage”, We cannot guarantee against improper use or unauthorized modifications of this information. “Heidi and Franny’s Garage” assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. “Heidi and Franny’s Garage”recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of “Heidi and Franny’s Garage”, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not “Heidi and Franny’s Garage”.

Hat’s worn by Heidi and Franny provided by: www.Fabkittenhats.com

For Correspondence:
Heidi and Franny’s Garage
P.O. Box 740487
Arvada, CO 80006

2,568
Like
Save


Comments

Heidi and Franny's Garage says:

Hi Everybody, How is the idle on your 3.2 Carrera? Actually, this process applies to most cars – just follow the service manual and get to know all the players. The vacuum gauge I used is this guy: https://goo.gl/xtoi9r and can be used for low positive pressure for carburetor fuel systems like maybe a 356 or VW beetle 😉 If you have idle problems across the temp range, the service manual will walk you through each of the possibilities. Test them before just replacing. The Temperature sensor on my car reads as an open circuit (SB 90-6.8KOhm depending on temp), but is working just fine. If I pull that plug while the car is running the idle will start to surge badly. Replacing the position, speed and temp sensors isn't too bad, but is a bit cramped and fiddly. Let me know if you have questions. …list of parts and tools in the description. Thanks! Franny

F. Scott Fitzhemingway says:

You are so super cool ! thanks for the videos!

Noe Martinez says:

Did you have to unplug your battery before unplugging the valve sensor? I think my 85 911 might be experiencing these cold idle issues.

IFRPilotMN says:

Wonderful video and very helpful- thank you Heidi and Franny!

Kayoed Owner says:

Hi Granny and Heidi, As always this was extremely informative, the methodical way you go through the diagnostics is a lesson in it's self!  Mine is a 991.2 so I can't even see the engine, let alone tinker with, it but still I find all your video's nothing short of fascinating.

Charles Jacobus says:

Good job, Franny! Chuck

steffydog1 says:

Interesting stuff, ta

Trevor Macdougall says:

Great video, Franny. Thanks. My 3.2 has been rough idle on cold so I will try cleaning the idle valve like you did and see if that helps. Merry Christmas!

Alex Mestas says:

Thank you again! Great Video. Pesky problems made easy. Enjoyed it.

Axel Hofmann says:

I wished we had such good Porsche technicians and such wonderful weather in Germany. Many thanks for so many interesting videos in 2017 and Merry Christmas to enchanting Heidi & Franny‘s Garage!

77abcdef77 says:

Hey guys, can you detail the procedure on the cleaning of the Idle Control Valve? What exactly do you do, and how do you prevent damaging it in the process? Anything to watch out for?

JOSÉ RODRIGUES ZEZICO says:

Hi Heid and Fanny´s Garage congratulations …Here in Brazil today is MECHANICS DAY.

18echosf says:

After watching all of your videos, I’m always amazed at just how thorough you are when diagnosing different issues. You definitely get a thumbs up from me! Best wishes to you and Heidi for a wonderful holiday season!

Reply to IFRPilotMN Cancel reply