Car Fix DIY Videos

Step-by-step guide on how to remove / replace / upgrade factory radio unit on Pontiac G5 sedan ( 2005 | 2006 | 2007 | 2008 | 2009 | 2010 | SE | GT | BASE ). I am pretty sure this video applies to Chevrolet Cobalt radio removal and replacement as well.

Before you can access four 7mm screws which are holding the radio in place, you will have to remove couple of plastic trim pieces. Once you pull the old radio out, disconnect the radio antenna and 2 connectors and install your new radio. If you are replacing with another factory radio make sure to get the radio CODE. If replacing your Pontiac G5 radio with aftermarket than you will need the right wiring harness, adapter and the radio kit.

Thanks for watching.
Don’t forget to LIKE it and SUBSCRIBE to the channel!

⚠ DISCLAIMER:
While QuiteAlright strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. The videos are intended for information only. Follow the manufactures repair procedure and use appropriate safety procedures. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. QuiteAlright is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.