Peugeot 308 how to wire dash cam to fuse box,simple guide.

Peugeot 308 how to wire dash cam to fuse box,simple guide.

Step by step video showing how to install your dash cam to the cars fuse box, so that it goes on and off with the ignition and has no cables hanging down. For models 2013 to 2018

40,595
Like
Save


Comments

discovery1512 says:

Followed the clear step by step guide provided in the video and completed the job without issue.
Brilliant tutorial and was prepared for the fiddly part of connecting feed wire to the fuse box thanks to this.
The comments from other viewers also ensured I didn't disconnect the wires in front of the fuse box for easier access, which would have seemed a perfectly reasonable thing to do, without knowing the awaiting pain when reconnecting the wires. Thank you.

Chris W. says:

Thanks. Did my 2015 307 today and this really helped.

Krume Cesnoski says:

Wow. The fuse box is real mess !

chris says:

Peugeot 207 is impossible to do this,I found a good earth point,I pulled loads of fuses where power is off with ignition off,pulled cigarette lighter fuse added the piggyback in both directions and no cigarette lighter,put the fuse back and it works,I've tested the piggyback with a meter and shows no faults

karpetcabin says:

I installed a dashcam watching your video. It would start recording when I turned key in ignition but recently it has stopped working. A message came on screen saying low battery and then it switched off. I had thought it was being powered by car. Any ideas?

Lukasz says:

I have a pre-install dashcam cable by the mirror but there is no power in it. Do You know maybe which fuse will be responsible for it? or haw to find it? Peugeot 308 2019

Konrad Nowicki says:

Great tutorial. Just finished the installation of my dash camera (front and rear). I encountered a few problems with hiding cables in the head liner as i didn't know how far should I push the cables. Then I couldn't find a right fuse diagram for my car (or I just don't know how to read them).

Once everything was set up, I couldn't get to power up the unit. I spent like hour changing and replacing fuses. Turns out the micro USB adapter was disconnected xd.

Anyway I get there at the end.

Yan P. says:

Thanks a lot

Christopher Lowe says:

This video is very useful, thank-you! I’m going to wire my dashboard camera into a fuse that’s always on so that I can enable parking mode – can you recommend which fuse/accessory to use for this? I drive a 2015 Peugeot 308 GT. Thanks in advance!

cedric Jambilloux says:

hello, thank you for your video, can you tell me the located fuse inside the box ? letter& figure ? and his "Amperage" , thank you for your help, i will try to set on the 308 2019, thank you.

Comments are disabled for this post.