How to Replace Rear Brakes 02-15 Nissan Altima

How to Replace Rear Brakes 02-15 Nissan Altima

https://www.1aauto.com/nissan-altima-maxima-sentra-brake-kit-rear-nakamoto-cd905%2c-43206-7y000/i/1abfs00348?utm_source=YouTube&utm_medium=description&utm_campaign=videodesc&utm_term=q7-m7d60i8o
1A Auto shows you how to repair, install, fix, change or replace your own worn, squeaky, fading old brakes. This video is applicable to the 02, 03, 04, 05, 06, 07, 08, 09, 10, 11, 12, 13, 14, 15 Nissan Altima.

✔ List of Auto Parts from 1AAuto.com Related to This Repair:

1ABFS00348

🔨 List of Tools Used in this 1AAuto.com How-To Video:

• Flat Blade Screwdriver
• Pry Bar
• 14mm Wrench
• 19mm Wrench
• 21mm wrench
• 14mm Socket
• 19mm Socket
• 21mm Socket
• Dead Blow Hammer
• 1/2 Inch Breaker Bar
• Ratchet
• Torque Wrench
• Brake Parts Cleaner
• Bungee Cord
• Cloth Rags
• Paper Towels
• Rust Penetrant
• Center Punch
• Floor Jack
• Jack Stands
• Wire Brush

🔧 Instructions:

1. Removing the Wheel 0:17
2. Removing the Brake Pads 0:46
3. Removing the Brake Rotor 4:33
4. Installing the Brake Rotor 6:13
5. Installing the Brake Pads 8:20
6. Installing the Wheel 13:27

⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

14,135
Like
Save


Comments

bku downlol says:

arent you suppose to use a caliper rewind tool for the rear pistons so you don't potentially break the parking brake? I thought it was only safe to use a C clamp on the front rotors

Simon SP says:

is it the same procedure for 2011 Nissan Sentra SE-R 2.5, more specific, the guide pin with the boot at the end, does it go in the lower or upper part of the caliper?

Write a comment

*