Buy Now!
New Brake Kit from 1AAuto.com http://1aau.to/ia/1APBS00404
1A Auto shows you how to repair, install, fix, change or replace your own worn, squeaky, fading old brakes. This video is applicable to the 09, 10, 11, 12, 13, 14 Nissan Murano
🔧 List of tools used:
• Flat Blade Screwdriver http://1aau.to/oYr/1AXAA00013
• Pry Bar http://1aau.to/ofg/1AXAA00020
• 10mm Wrench http://1aau.to/okp/1AXAA00010
• 14mm Socket http://1aau.to/oPe/1AXAA00015
• 19mm Socket http://1aau.to/omV/1AXAA00043
• 22mm Socket http://1aau.to/obt/1AXAA00266
• 1/2 Inch Breaker Bar http://1aau.to/ohB/1AXAA00078
• Ratchet http://1aau.to/oZI/1AXAA00016
• Torque Wrench http://1aau.to/op5/1AXAA00044
• Brake Parts Cleaner
• Rust Penetrant
• Floor Jack http://1aau.to/oox/1AXAA00068
• Jack Stands http://1aau.to/ooG/1AXAA00065
• Large C-Clamp
• Wire Brush http://1aau.to/oc8/1AXAA00079
For More Info visit us at http://1aau.to/h/aIw/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
√ Do it Yourself
√ Save Money
There is no need to open the bleeder unless there was air in the line to begin with.
Good video thank you !
Thank you so much for this very informative video.
If you do not bleeding the brakes, would you have issues with the pads grabbing the rotor. I can feel the front brakes shim-ing
I saw the nail when she was putting the tire back….great video….thanks for sharing.
should it be 122 nm? I think 122 ft lb is too much.
Not sure why u bled the brakes? I just pull the lid off master cylinder and push the piston back on the caliper introducing no air in to the line
Very clean professional job. Great video. Thanks!
In 4:10 do u have to squeeze out the water or no
Do I have to change my rotors every time I change the brakes or how do I know when I need to change them.
Nail in the tire!
Two Thumbs Up….