Today we are going to install our brand new 2″ Leveling Kit.
Hopefully with some of the tips I shared it will save you time, and the headache I got for having no instructions, or the right tools.
This video is Sponsored by viewers like you at Paypal:
https://www.paypal.me/DDNshopfund
Frontier Lifestyle Apparel
shop.spreadshirt.com/frontierlifestyleapparel
facebook.com/frontierlifestyle
instagram.com/frontierlifestyle
Please leave a comment in the video if you have any questions.
Essential tools needed to perform Install:
1/2″ drive
14mm (upper strut nuts)
17mm + Box wrench (sway bar)
19mm + Box wrench (lower strut bolt)
21mm + Breaker bar (lug nuts)
23mm (ball joint nut)
floor jack or bottle jack
jack stands
#nissanfrontier #liftedfrontier #liftednissan
Link in the description of the spacers I used. Thanks for watching. Comment below if this helped you.
That's exactly how I do life I rubber mallet the shit out of it.
This is probably the most realistic video on YouTube of working on a car hahaha. Respect for keeping it all in!!
i added a 2" lift on my 2015 frontier and cant get the camber correct- even maxed out I'm still 1.4* off (tipped in)… how'd you correct this issue?
If i do a 2" lift to my 15 frontier do i need to do anything to the rear? Thanks
the rubber mallet turned out to be a comical bit but I was crossing my fingers you were going to find a sledge hammer haha. I don't recall you mentioning the bump stop that goes on the UCA(upper control arm) because the coil bucket can make contact and eventually create a weak area for the coil bucket. Otherwise keep up the vids, I love to see frontier stuff and get ideas from people doing different mods
Do you get coil bucket contact from using a spacer? Did you have to do an alignment afterwards? Did you have to install camber bolts. Thanks.
I’m looking at adding a 2” front 1” rear on my 17 CC, based on your experience, you think I’ll be good to go with stock UCAs?
Can this be done on an '07 Nissan Quest?
damn, that looked like some tough work. got you all huffin & puffin lol. I just got my 1st midsized truck (Nissan Frontier 2019 2wd). I might've forgotten but is yours a 4wd or a 2wd. I'm thinking of leveling it so I can raise it a bit… thoughts?
What about camber bolts ?
That's a san Bernardino or riverside tatt right
So how much lift did you get on your front diff?
Thanks for the tip man…. it will definitely save me time because of you video…
it would have been better if you had all the tools before you started lol.
What did you're front puck spacers measure out at