Tech Tips: Resolving Thermistor Errors (L)

Tech Tips: Resolving Thermistor Errors (L)

[updated 1/24/2018: Legal disclaimer added]
Resolve thermistor errors properly and quickly using the tips in this video.

74,616
Like
Save


Comments

John Wilson says:

Well this is a good start but there is also 1 big thing that is not talked about. The Mitsubishi DPLS2 drain pan level sensor. It makes you remove thermal sensor from board with a pig tail to install sensor downstream. This module was bad and caused P1. Installed original senor back in the board all set. FYI

Robin Patel says:

Sir, I have a Mitsubishi electric inverter Mr. slim ac and it's the outdoor fan is not working and the outdoor PCB of my ac keeps blinking 6 times.. After some time the indoor light also keeps flashing so sir can you suggest to me how to fix this error.

Jeneen Brown says:

Works so well Fastly.Cool that it only requires daytime operation until high temp and humidity are overnight. It is difficult to get to side filters, but back is easily accessible.

Richard Yap says:

The board is very expensive.

Ravindra Adyanthaya says:

Tell me the resistance value of coil sensor and room sensor

Richard Maritz says:

Hi,my ac is brand new,it's av12000 btu,it cools and heats my room very good,but on the remote I can press a button and it would tell me the room temperature,now if I set my unit to 23 degrees celsius and check the room temperature it will sometimes go 22 degrees Celsius,before it would shut down,is this rite? Thank you

D Lee says:

Will replacing my remote on my mR sLIM msz-fe18na unit fix my heating issue? It keeps running even after setting the thermostat on remote to 59. Installer didn't know how to fix. It just keeps heating the room to the point I have to shut it off

Comments are disabled for this post.