This video is a total removal and reinstallation or a small block 350 5.7ltr V8 Mercury MerCruiser.
“HOW TO”
Engine
transom assembly
helmet
outdrive
Etc…
Thanks for watching
Check out my Facebook and instagram below
chefoutdoors.com
Dancopliers.com
Doalures.com
firedisccookers.com
INSTAGRAM
https://www.instagram.com/chefoutdoors/?hl=en
FACEBOOK
https://www.facebook.com/Chef-Outdoors-102969627822442/?ref=py_c
I have alpha 1 gen 1 outdrive, can I change it to bravo outdrive? Thank you
How much would it cost to remove a 3.0 volvo penta engine and put a 4.3 mercury engine in
BEST video ever – Great job Chef!
How long did it take y'all to do this job?
The donkey dick, hahahaha
Why didn't you change the gamble bearing and boot
what did you use to pull the engine out?
Background music name??
Editing makes it look soooo easy, LOL
should have put dielectric grease on them postive cables connection to the starter motor, so they wont rust up etc
hope ya put sealant inside the holes the bolts are in
U missed the point of the video – how you pulled the engine
Bravo fit on Alpha transom?
Great job sir. Do you have to take the outdrive off if you are only swapping out the engine? I gotta put a new 350 in my dads trophy. Thanks
Does your starter require a 90amp fuse for the solenoid? The battery was hooked up backwards on for my mercruiser 350 and it tripped the breaker on the motor, but there's no fuse on the solenoid and I think it trashed the starter.
Awesome video! How many hours did u guys spend on doing this job ? i´m about to do the exact same procedure this week..
Great job! I am planning to get a 1977 Mercury Marquise. Engine: Mercruiser 4788052. The body of the boat looks impecable; however, the owner told the seal between the engine and the outside part might need to be replaced. Any ideas, suggestions on this, please? How advisable for me it is to buy something like this? I am a new comer and has zero knowledge on boats. Thank you!
Great work!