Today we are using a Linear actuator to fabricate a power trim/lift for my 1978 Mercury outboard. Thanks for watching!
https://amzn.to/2XEPH9w
Shop On Amazon
Linear actuator link
https://www.amazon.com/gp/product/B07TYXSKM8/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1
Interested to see wiring/ switch
This is great! Thanks for the video. You still put the locking pin in the motor after you tilt it down, correct?
Does this mess with the turning ability?
I’d like to see it work in the water ?
now you have to see if it can push against 50hp when its running !!! i doubt that very much..
Idea is great, do you think it would lift higher if you swapped the actuator and the bar? So the actuator would be pushing up instead of down.
Does that work with the boat under power? I have the same motor missing the expensive trim and tilt. I am definitely following your design. Thanks for sharing!
What is the actuator brand and travel length
Thanks in advance
I definitely want to do this
Good ingenuity & mechanics but incorrect placement of the actuator, place it at the bottom of the Transom outside in the middle & connect it to the inside edge of the lower unit with a bracket & watch your actuator’s efficiency go up tenfold. It will be a tight fit, you might have to get a shorter actuator or work out a 360 bracket to accommodate the length while the motor is down but that’s what DIY is about. This setup does not work because it is too slow to bring up the motor in critical situations, direct attachment will transfer the torque into movement more efficiently. But you guys are great & very helpful! Keep rocking!
I like this idea. Do you have any issues with the motor hitting the actuator while turning? I’ve got the same 50 hp Merc!! Solid motor!
We’re did you get the lift motor?
Great idea! But a couple questions, Did you just do that for transportation ? Can it be used with the motor running in shallow water?
What weight can these lift ? Would possibly do as a jack plate ??
Sou do Brasil como faço p colocar no meu motor Yamaha de 40 hp
That was real cool to see. I guess you could maybe take your pal fishing for helping you out with that.
Pretty cool
Now that is pretty cool, Ole Scott is one fart little smeller. You are lucky to have a friend like that around.
Y'all couple fart smellers, I mean smart fellars… lol sweet…
I have been thinking about using a couple of Linear actuators to build a dump bed for my trailer
I have found out what's wrong with the shifter. Wait till I'm back there Wednesday