Mazda 5 transmission control module replacement with new unit and new location. Hard shift went away and jerk into reverse went away. P0733 p0744 codess went away after VSS sensor replaced. Solenoids replaced. all 6 for $56 dollars on ebay. Runs great now. watch my other video on all the sensors, location, replaced. thanks
My TCM was bad…..but my transmission torque converter "solenoid " was bad as well. TRANSMISSION CODES WERE: PO733 AND P0744 was solenoid………
Was that a manual you have? I'm ordering a different serial number that is for F and B… but mine is auto. so if yours was manual i know it's fine.
Thank you very much for this video. You helped me so much.
My mazda 5 2008 model is driving/shifting but at moments it just starts shifting in and out of different gears on its on jerking. (While in drive) could this be problem
Did your High rev going into 3 rd gear go away ?
Does the tcm need programming with cars vin number? Thanks
Where did you buy yours ?
Hello,do you know if I can use the tcm from Mazda 5 in my Mazda 3 2.0L?
Tcm code P0763
My 2015 Mazda 5 has 75k miles on it and I will relocate the TCM just to prevent it from overheating. Thank you for the video.
90% of Mazda transmission problems is TCM . I recommend buy on from EBAY, and if it doesn't fix the problem send it back. But start with this.
Thank you so much for your video and let us know what can be the problem in this van.
My gf's is acting weird and it's loosing speed but i believe it has the same problem as yours.
Thanks again and good luck in projects 🙂