Running big tires on a Disco/LR3 or 4??
This kit is an absolute must!
It has already legitimately “Saved My ***” in the past sixth months… do yourself a favor and get this piece of gear! Kudos to Proud Rhino for another fantastic product.
Hope this video helps you through your project (sorry I didn’t get any film of installing the limit straps).
Suspension/Handling Factors FYI:
Green Oval Experience (GOE) rods
Grabber X3’s in 275/75 on 18×8″ Steel Wheels from Lucky 8 (Terrafirmas, I believe)
IID Tool (+~10mm)
Full Tactical Rovers Armor (front, rear, & sides)
——————————————————————————————————-
MUSIC:
Another Brilliant Age by Jelsonic is licensed under a Creative Commons Attribution License.
http://freemusicarchive.org/music/Jelsonic/ for more by this great artist!
Great video! nice tire carrier bumper kit! Is it custom?
Thank you very much for the video!
Would we them be able to for in 35" tires?
My compressor gave up assume time ago and The drive was very low scraping, etc… Does this guarantee a higher lift when the air suspension is dead or can it be used as a lift with the air on?
Sorry I'm gullible and stupid!
Thanks again (-:
Great videos, please can you tell me or make a video of the gas can and tire carrier install or where to get it. Thanks in advance
Got any more videos on the LR3?
What size tires are you running?
I’m putting together my LR4 and wanted some tips on front and rear bumpers. The idea is to run a winch and have the spare above the rear bumper
Prefer to stay air or thinking of switching to coil?
Great video, did you change anything else? I read that you have only installed these spacers and LIFT RODs, but waht about the rest? Thank you I am building my LR3, thank you for the advice.
Great video but have question this lift kit can use also in a desert? And need another else to fit in car for safety?
Where did you get the front bar can I get it online?
What is the benefit of doing this over extended lift rods which attach to the height sensors?
Why would you do this? The LLAMS kit from Australia does the same thing electronically by putting an easily adjustable plus or minus offset in the position feedback sensors from each wheel. This is a mechanical offset. Not easily un-done. Didnt you know about the LLAMs system?