I put a 2.5 inch suspension lift on my LR3. Super Easy. Great results. Just pry off the old bars. (be careful of the sensors) and then slap on the new bars. When once complete you will likely need to manually tell your Rover to go to standard suspension height. It will then calibrate and you Rover has a new lift.
Did you have to get an alignment after installing the new lift?
Hey , what about the access height is it still available like before ? Nd are those rods overloading the compressor since more air is required to keep struts at high length? Thnx in advance
Thanks for sharing the video. Considering a used LR3 for offload service since I've moved to Arizona, so plenty of offload potential. I'm not sure who makes these rods, however, this would be another manufacturer that seems to be popular: http://johnsonrods.com
where did you get the left kit?
What happens when going offroad and setting it to high or when vehicle goes into extended high mode? Have you popped an airbag or unlike older generations is there a limit stop?