How to Replace Wheel Hub Bearing 07-17 Jeep Wrangler

How to Replace Wheel Hub Bearing 07-17 Jeep Wrangler

Buy Now!
New Wheel Bearing & Hub Assembly from 1AAuto.com http://1aau.to/ia/1ASHS00920

🔧 List of tools used:
• Pry Bar http://1aau.to/teW/1AXAA00020
• 13mm Socket http://1aau.to/tadB/1AXAA00015
• 19mm Socket http://1aau.to/tqh/1AXAA00043
• 21mm Socket http://1aau.to/tqh/1AXAA00043
• Brake Caliper Hanger http://1aau.to/td/1AXAA00084
• Trim Tool Set http://1aau.to/tjT/1AXXX00004
• Needle nose pliers http://1aau.to/tkR/1AXAA00051
• Needle nose pliers http://1aau.to/tkR/1AXAA00052
• 1/2 Inch Breaker Bar http://1aau.to/thJ/1AXAA00078
• Ratchet http://1aau.to/t7L/1AXAA00016
• Socket Extensions http://1aau.to/tadB/1AXAA00015
• Torque Wrench http://1aau.to/tqH/1AXAA00044
• Anti-Seize Grease
• Brake Parts Cleaner
• Rust Penetrant
• Floor Jack http://1aau.to/trv/1AXAA00068
• Jack Stands http://1aau.to/trT/1AXAA00065
• Wire Brush http://1aau.to/tdA/1AXAA00079

For More Info visit us at http://1aau.to/h/bhX/

1A Auto shows you how to repair, install, fix, change or replace a worn out, vibrating or groaning front wheel bearing hub. This video is applicable to 07, 08, 09, 10, 11, 12, 13, 14, 15, 16, 17 Jeep Wrangler

⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

2,928
Like
Save


Comments

Jesse Petrone says:

What brand of wheel bearing does your part use?

Jesse Petrone says:

I thought the hub bolt was a 36mm. It was on mine

Jason Fawbush says:

I googled the 12 point screw versus 6 point hex debate, and the answer seems to be they fit in tighter spaces and can give you more surface for the socket to engage without rounding off. I guess it all depends on the head size chosen. Thanks for making the video.

Mikey Meatball says:

Is blue loctite required too? Also, do you risk bending the axel using that four pound hammer?

Comments are disabled for this post.